Installation guide for FLEXI10

Make sure you have the dongle and the password key ready, before you proceed.

Do not insert the dongle into the USB yet!

Install the drivers for the Sentinel Safe Net dongle available at

How to install the flexi 10 Starter:

Place the CD in the CD Drive, if the auto play doesn't start, open the

click on the icon as shown below

.

Choose english and click OK

Installation guide for FLEXI10 Starter

Make sure you have the dongle and the password key ready, before you proceed.

Do not insert the dongle into the USB yet!

Install the drivers for the Sentinel Safe Net dongle available at http://www.safenet

Starter:

, if the auto play doesn't start, open the CD Drive in my computer and

click on the icon as shown below.

Starter

Make sure you have the dongle and the password key ready, before you proceed.

Do not insert the dongle into the USB yet!

http://www.safenet-inc.com/drivers

CD Drive in my computer and

The setup will carry on:

Read through and click on Next

Read the license agreement and

Keep it same , click Next

Read the license agreement and select “I accept the terms......” click on Next,

Make sure these three boxes are ticked and then clic

The setup status bar will show up.

re these three boxes are ticked and then click on Next

bar will show up.

In the install manager, put the dongle key found on the back of the box of the software or either on

the cover of the dongle. It should be about 16 digit to 18 digits depends from box to box. Put the

password where it says “flexi password goes here

In the install manager, put the dongle key found on the back of the box of the software or either on

the cover of the dongle. It should be about 16 digit to 18 digits depends from box to box. Put the

flexi password goes here “.

In the install manager, put the dongle key found on the back of the box of the software or either on

the cover of the dongle. It should be about 16 digit to 18 digits depends from box to box. Put the

Then select flexistarter 10.0.1 and click on done and then ok.

Insert the dongle in now, make sure the light turns to green and

tarter 10.0.1 and click on done and then ok.

Insert the dongle in now, make sure the light turns to green and it’s installed properly.

installed properly.

Setting up the software:

Before carrying on with the next steps it is important to know which USB port th

attached to. In order to check, Right click on My Computer

carrying on with the next steps it is important to know which USB port th

. In order to check, Right click on My Computer

carrying on with the next steps it is important to know which USB port the cutter plotter is

For this computer, the cutter plotter is attached to USB port COM1.

Next insert the Dongle into the USB port on your computer. Windows will automatically detect it

as a new hardware and the following message would pop up.

Then, double click on the Flexi 10 Starter icon,

It would then open the Flexi 10 starter Dashboard.

Click on sample text by clicking the T on the left and type some text, in this case, we typed TEST.

Now click on the cut/plot from file option, the production manager will open and the following

screen will pop up. Change the setting as follows:

SC631e/SC631 – Brand Liyu Cut, Model - SC

TC631/TC631E – Brand Liyu Cut, model – TC

PCUT –Creation PCUT, Model CTO630

For Creation PCUT CTO630, you need download and install the following plug in:

http://download.ukcutter.co.uk/drivers/Flexi/ Download the file and read the ‘Read me’ file.

Make the necessary changes, as shown above. Change the port settings as per the COM port

settings.

Click on finish.

Right click the icon and click on test cut and you are now ready to cut.