INSTALLATION INSTRUCTIONS

CUSTOM WIRING CONNECTOR

WIRING LOCATION GUIDEAPPLICATIONS

NOTICE

WARNING

TOOLS NEEDED

Signal Circuits - 3.0 amps per side Tail / Running Circuits - 6.0 amps total

Check vehicle owner's manual or contact the vehicle manufacturer for more information.

Flat blade screwdriver

Panel trim removal tool

Phillips screwdriver

The battery connection must be fuse-protected, 10-amp max. Exceeding the product rating can cause loss of warranty, overheating and potential fire. Do not exceed product rating or tow vehicle lamp load rating, whichever is lower.

Make ModelHonda CR-V

WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER

SUVS, MINI & FULL-SIZED VANS (S)Representative vehicle shown below

S3 - Behind driver side rear access panel

S3

All steps must be followed to ensure the wiring connector will function properly. Once installed, test for proper function by using a test light or connecting a properly wired trailer.

PAGE 1 • 56370-INS-RA

A B

H

C

D

G

J

I

E F

Step 1 Open the vehicle tailgate. Remove all trunk floor coverings (A).

Step 2 Remove the fasteners securing the rear scuff panel. Remove the scuff panel by pulling out on the bottom and then up. Take care not to damage the alignment tabs on the back (B).

Step 3 Fold both rear seats down. Locate and remove the two cargo tie downs from the rear seat floor panel. Remove the screw located under the cargo tie down cover holding it in place (C,D).

Step 4 Remove the storage trim panel behind the rear seats by pulling upwards (E).

Step 5 Remove the center ceiling trim panel by pulling straight down. Take care not to damage any alignment tabs on the back (F).

Step 6 Starting on the driver side, remove the push fasteners securing the side trim panel (G).

Step 7 Remove the small cover behind the rear seat fold down lever (H). Remove the two screws securing the side trim panel in place (I). Pull out on the interior side panels to locate the vehicle trailer connector (J). Take care not to damage the alignment tabs on the back.

INSTALLATION / SAFETY INSTRUCTIONS

56370-INS-RA • PAGE 2

K L M

Step 8 Behind the upper side-trim panel, locate the vehicle taillight wiring connector. The connectors will be similar to the connector on the custom wiring connector and will be secured to the vehicle wiring harness (K).

Step 9 Insert the custom wiring connector into the vehicle connector. Make sure the connectors are fully inserted with locking tabs in place (L).

Step 10 Locate a flat spot inside the vehicle, near the taillight. Adhere the black converter box using the provided double-sided tape (M).

Step 11 To complete the installation, insert the provided 10-amp fuse into the in-line fuse holder.

Step 12 When in use, route the 4-flat to the center of the vehicle and out of the trunk. When not in use, roll up and store in a convenient, out of the way location inside the trunk. Secure any loose wires with the provided cable ties.

Step 13 Reinstall all items removed during install. Install the provided 4-flat dust cover to help prevent corrosion.

INSTALLATION / SAFETY INSTRUCTIONS

PAGE 3 • 56370-INS-RA