Upload
dionison-ataide
View
214
Download
1
Embed Size (px)
DESCRIPTION
Intalação do Couchmaster
Citation preview
Inside: 2 big support cushions, 3 wrist pads. 1 mouse bag, 1 plastic support case, Velcro tape (inside the mouse bag) and 1 envelope with the documents (Velcro points, flyer, sticker).
Depending on model: 1 USB hub, 16 ft. (5 m) USB 3.0 cable.
Components on the right hand side.
Turn the support case around and open it by pulling the slots at the back.
In the envelope of documents you will find some Velcro points. Stick them on every designated area inside the support case. For optimal usage, place them on each corner.
©2014 by nerdytec.com • illustrations by wappworx.com
installation guide
Now turn the support case around again and attach the mouse bag to the front of the support case. You can choose the most suitable position for optimal accessibility. The position on the picture is perfect for right handed people.
If you need them you can use the wrist pads on the support case, by attaching them to the most suitable position.
1
1a
2
3 4
5 6
Your Couchmaster should look something like this.Proceed by installing your keyboard and mouse.
Turn the support case around again and press out the small round covers.
Fix the USB hub inside with the Velcro tape. The best position is the side in which you use to take out the USB cable that goes to the computer. Then connect all devices ( mouse, keyboard and head-set) to the USB hub. The micro USB cable that will be connected to the USB cable must be connected on the head of the USB hub.
After you‘ve installed all devices, close the support case and press softly on each point where you’ve stuck the Velcro points inside.
Lastly, connect the micro USB cable to the active USB extension cable and plug it into your computer.
©2014 by nerdytec.com-• illustrations by wappworx.com
Thanks for thrusting in our products and have much fun with your exclusive COUCHMASTER ®
Zum Scheider Feld 6c51467 Bergisch Gladbach
[email protected]+49 2202 9276614
Pass the keyboard and mouse cable through the hole shown from outside. Attach the mouse and keyboard with Velcro tape on the support case if you wish. To do so, take the Velcro tape from inside the mouse bag.
7 8
9 10
11 12