CLEARWATERFOrmOsO Freestanding bath

Cleaning reCOmmendatiOns

To see the complete CLEARWATER range go to www.reece.com.au/bathrooms

sPeCiFiCatiOnsrecommended Use Domestic, Hotel and Commercial

size 1500mm x 750mm x 555mm

1700mm x 750mm x 555mm

material Composite Stone Solid Surface

Weight 1500mm: 92kg

1700mm: 120kg

Capacity to overflow

1500mm: 300 litres

1700mm: 362 litres

Colour White

thickness 18mm

disclaimer: Products in this specification manual must by regulation be installed by licensed and registered trade people. The manufacturer/distributor reserves the right to vary specifications or delete models from their range without prior notification. Dimensions are nominal measurements only. Dimensions and set-outs listed are correct at time of publication however the manufacturer/distributor takes no responsibility for printing errors.

tech Page Version 2

Formoso Piccolo 1500 x 750 x 555

Product SpecificationFinishes whiteProduct Type natural stoneMaterial natural stoneTap Holes 0Product Weight 92kgBath Water Volume 300 litres * / 230 litres *** Volume of water contained in the bath if filled to the overflow.** Volume of water contained in the bath if filled to the overflow less 70litres to allow for an average person in the bath.   Additional InformationIntegrated overflowAverage thickness throughout the bath is 10mm

Guarantee

See our website for terms and conditions Compliance / ApprovalsBS EN14516:2006Baths for domestic purposes 

All dimensions are in millimetres (mm)  

Compatible ProductsCW1 - Click-Clack Waste (slotted), CW3 - P Trap

www.clearwaterbaths.co.uk

Formoso 1700 x 800 x 555

Product SpecificationFinishes whiteProduct Type natural stoneMaterial natural stoneTap Holes 0Product Weight 120kgBath Water Volume 362 litres * / 292 litres *** Volume of water contained in the bath if filled to the overflow.** Volume of water contained in the bath if filled to the overflow less 70litres to allow for an average person in the bath.   Additional InformationIntegrated overflowAverage thickness throughout the bath is 10mm

Guarantee

See our website for terms and conditions Compliance / ApprovalsBS EN14516:2006Baths for domestic purposes 

All dimensions are in millimetres (mm)  

Compatible ProductsCW1 - Click-Clack Waste (slotted), CW3 - P Trap

www.clearwaterbaths.co.uk

Dimensions are nominal measurements only

We recommend the use of soapy water or approved cleaners.

This product should not be cleaned with abrasive materials.

Damage caused by any improper treatment is not covered by the product warranty- Refer to Warranty Conditions.

page 1 of 4

CLEARWATERFOrmOsO Freestanding bath

installatiOn instrUCtiOns

Plumbers, please ensure a copy of the installation instructions is left with the end user for future reference

Important

• Please unwrap the bath and check it carefully to ensure it has not been damaged in handling or transport.

• Please check that all parts have been supplied.

• Assemble bath on a mat to protect against damage to bath surface.

• Any installation should be carried out by a qualified tradesman with knowledge of statutory plumbing requirements in your area.

• This product requires a two person lift – use proper lifting techniques.

• This installation guide does not include details of waste connection; final decision about installation of waste connection should be taken by a suitably qualified person.

Parts supplied:

1x

1

4x

3

When fitting the waste, ensure the slotted side faces the overflow channel.

Slot

Overflowchannel

Parts supplied:

1x

1

4x

When fitting the waste, ensure the slotted side faces the overflow channel.

Slot

Overflowchannel

For more detail, refer to the instructions supplied with the waste Waste supplied in kit V75-DF muxt be used

4x

24H

Place the bath on two wooden blocks over the waste connections. Connect the waste. Fill the bath with water and check for leakage. Place the wedges in position.

The wedges can now be disposed of.

(wedges not supplied)

page 2 of 4

CLEARWATERFOrmOsO Freestanding bath

Plumbers, please ensure a copy of the installation instructions is left with the end user for future reference

Cleaning and Repair Guide

Scratch

(For best results limit sanding to the smallest)1 Remove the deep scratch by rubbing with a 800+grit sand paper2 If needed continue to remove by rubbing with a 1500+ grit waterproof abrasive paper and water3-5 Using toothpaste to polish the area to get back the gloss surface6-7 For best results, use electrical polish pad with neutral automotive colour restorer or houshold metal polish.

Shoe Polish

1 Wipe off with a soft cloth2-4 Using toothpaste to polish the area to get back the gloss surface

1 2 3

4 5 6 7

1 2 3 4

Cleaning and rePair gUide

page 3 of 4

CLEARWATERFOrmOsO Freestanding bath

Plumbers, please ensure a copy of the installation instructions is left with the end user for future reference

Grease or hand mark

1-3 Using non abrasive bathroom cleaner or mild detergent to clean the area to get back to the gloss surface.4-6 For the hard crease, using toothpaste to polish the area to get back to the gloss surface.

1 2 3

4 5 6

Pencil

1-3 Using non abrasive bathroom cleaner or mild detergent to clean the area to get back to the gloss surface.

Marking Pen

1-3 Using non abrasive bathroom cleaner or mild detergent to clean the area to get back to the gloss surface.

1 2 3

2 31

page 4 of 4