8/12/2019 JAPANESE GAS HEATER OPERATING INSTRUCTIONS.docx

http://slidepdf.com/reader/full/japanese-gas-heater-operating-instructionsdocx 1/2

JAPANESE GAS HEATER OPERATING INSTRUCTIONS

/ hairu/kiru : on/off power button unten : run(start) nenshou: burner on (fire)

Jikan - chosetsu : timer setting [down/up]When you adjust knob (or pess ▼ or ▲ buttons), the lower green light in the first picturelights up and the display changes to show the set point of room temperature. (10seconds later, the display automatically returns to the current room temperature theupper green light turns on).

oyasumi : timer – Night - Sleep (stops after 1 hour) When you push"Oyasumi/Good Night" button the green light over the button lights up and the gas fanheater automatically turns off one hour later.

ohayo : timer - wake up-morning (set timer 30 Min ~ 24 Hrs.) When this timerbutton is on adjust time with up/down (after how many hours you want to automatic turnon heater).

genzai- sitsuon : present room temp ˚C settei : Thermostat : room temp setting [auto] lock [for child] Press to lock (disable controls), press and hold to unlock

(enable controls).

There is a manual on the web, but it's Japanese.http://home.osakagas.co.jp/support/manua... 482'

For basic usage. You just press / (run/burn) button to Turn On / Off.If you want it more warmer, you press (upward allow) on / (room temp/time)

button: If you want it's too hot, you press V (downward allow) on / (roomtemp/time) button.If you press and V at the same time for more than 1 sec. the operation panel becameoperationally locked. It's kind of child proof. You press them once again for >1 sec. thelock is released.You can find alley of 8 lamps at the top. " (low) 16 18 20 22 24 (high)" A indicatorlamp blinks to show the current temp, and another indicator lamp light to show the settemp. If you set the set temp at , it keep on running at its max. no matter the roomtemp. is, if you set it , it runs at its minimum power no matter the room temp is.

8/12/2019 JAPANESE GAS HEATER OPERATING INSTRUCTIONS.docx

http://slidepdf.com/reader/full/japanese-gas-heater-operating-instructionsdocx 2/2

If you press (capacity switch) button to turn on the indicator lamp above, itprevent running maximum heat/flow and save the energy up to 30%. This is for thoseairtight houses.

Other buttons, ("good morning" timer) and ("good evening" timer)are for timers. You should forget about them, I even don't use.

When you get red indicator light at the (filter), you need to clean the filter onthe back side of the unit.