jf504 Procedure

7/23/2019 jf504 Procedure

1/22

Procedure

The steps to create my project is as follows.

Below are the steps in creating the modelling of the project :

A block diagram with a width of 150mm and height of 100mm is created and this block isthen extrded to 1!mm


2/22

Two lines are drawn on each sides with a width of 5mm and hei ht of 100mm.

The two lines are then extruded subtract to 4mm

A box is drawn on the surface of the block


3/22

Then the box is cropped to be in an arched shape

ext! the box shape on the block is extruded (subtract) to "mm


4/22

ext! a c#linder shape is drawn on the block. The radius for the c#linder is 4mmand the length of the c#linder from the center point is 110mm.


5/22

The c#linder shape on the block is then extruded (subtract) b# $mm

%o&ing on! 5 circles with a radius of $mm is drawn on both sides of the block.'ach circle is distanced at 15mm


6/22

The circles are then extruded (subtract) thoroughl# which is 1mm

Then! three cone shape like diagram is drawn on the bottom surface of the block.To do this! $ circles are rstl# drawn with a centerpoint of *mm from bottomsurface of the block and lines are drawn on the sides of the +uadrant of the circle


7/22

The shape is the extruded (subtract) b# 5mm


8/22

"ext are the steps on creating the simlation and #$codes :

,lick the -tart/ icon and choose -%anufacturing/ command.

ext choose -camgeneral/ and -millplanar/ and click -2/


9/22

,lick on the -,3 ialog/


10/22

rientate the axis as abo&e and click -2/.

ow click -6278','/ and #ou will be directed to the following window as


11/22

,lick on the -pecif# 7art/ icon

elect -9eometr#/ and click on the -elect All/ button and press -2/

,lick on the -pecif# :lank/ icon


12/22

elect -Auto :lock/ and press -2/


13/22

et the -iameter/ to 5.00 and the -Tool umber/ to 1

ow select -,reate Tool/ icon from the status bar and #ou should see a windowas abo&e. hen #ou see this window. 7ress -2/.


14/22

ext click on the -,reate peration/ icon and #ou will prompted to the windowsabo&e. elect -mill;contour/ and change the name to -7696A%10/. ow click

%ake sure #our data matches as the window abo&e.


15/22

%ake sure the data matches as abo&e and click on the -tock/ button for the

croll the window and click on the -,utting 7arameter icon/


16/22

,lick on the -


17/22

ow click on the -9enerate/ icon

,hange the -urface peed/ and -


18/22

This is the windows that #ou will get. 3ou can pla# the simulation b# clicking onthe -$ #namic/ icon. Then click -ka#/

3ou can now see the generated simulation lining on the :lock. 3ou can now clickon the -&erif#/ icon on the bottom


19/22

This is the output le where the generated -9,odes/ will be shown.

,lick on the -7ost7rocessor/ icon on the status bar abo&e and #ou will see thiswindow. elect -%8==;4;A>8/. ow click -2/


20/22


21/22


22/22

Documents

jf504 Procedure