First Layer Height=.35 & Solid Layers Bottom=3 Layer Height
Solid Layers Top=3 If Solid Layer Top=3 the top Three layers will
be printed solid Based on the Infill:Top/Bottom Fill Pattern. In
the image on the right The top/bottom pattern is Hilbertcurve. The
Infill Layer is an inner fill (non solid) Honeycomb layer.
Perimeters Infill Layer
Layer 1 default fill Layer 2 applied parameters Layer 2 applies
the Pattern, rectlinear, at the pattern spacing and angle. This
pattern will be repeated for the layer specified in by Raft Layers
2.5mm
Slide 23
10mm Pattern spacing=4mm Five Interface layers { { 10 Raft
Layers Pattern spacing change from 4 to 2.5