Upload
abd-malek-mohamad
View
228
Download
1
Embed Size (px)
DESCRIPTION
LED text Message board
Citation preview
1. Install program GBL Ledplay in C: or D: Drive
gbl_led_setup_v6.0.exe
2. Launch program GBL Ledplay
3. Click Parameter at the program tool bar
4. The following Hardware setup diaglog will pop up.
5. Change Type to Advance.
Key in 88888 in Password.
Click OK.
6. The following Hardware tools diaglog will pop up.
7. Click Base parameter tab.
8. Change the default values using the values as highlighted below.
9. Click Scan Parameter tab.
10. Tick Polarity Inverse ONLY.
Change the default values using the values as highlighted below.
11. Click Exit.
`
`
12. Return to Main Frame. NOW READY TO START.