VoIP USB PhoneCMP-VOIP21/31/40/50
1. Package contents- USB Phone (Base station & handset for
CMP-VOIP50)- CD-ROM with driver- Manual- USB cable- Extra front
cover (for CMP-VOIP31 only)
2. System requirements- Windows XP/2000- USB 1.1 Port (USB 2.0
recommended)- CD-ROM drive for installation 3. Hardware
installationStep 1: Connect the USB Phone to the USB port on PC or
notebook with the cable that is attached to it. For CMP-VOIP50,
connect the base station to the PC or notebook and install the
battery inside the handset. Also see under item 6. Base
station.
Installing the battery (CMP-VOIP50)
Step 2:Follow any instructions for software installation under
Windows operating system.
4. Software installation4.1 Skype softwareIf not yet installed
on the PC, download the latest version of Skype software from the
Internet and install this application.
4.2 USB Phone driverInsert the driver CD and install the USB
Phone driver. If the software does not start automatically, then
browse to your CD drive icon and find the setup file. Double click
on it and follow the on-screen instructions. This phone driver is
needed to make your USB Phone work with Skype software.
4.3 Skype configurationAfter the USB Phone driver has been
installed, double click on its icon to start the program. Skype
will show a pop-up window asking if you want to allow this software
to be used with Skype. Click to always allow the phone software to
be used with Skype.
5. Use of the keypadThe following paragraph describes the main
functions of the USB phone keypad. Different modelsmay have
different buttons, please refer to the appropriate description for
your model.
CMP-VOIP21/31:
Switch between tabs of Skype software/ To scroll through contact
list / calls in Skype window / adjust volume while talking Make or
answer a call End or refuse a call
C Delete wrong input (clear) while dialing. Other function: mute
the microphoneRING Press this key to cycle through the various ring
tonesMUTE Press to mute the microphone
CMP-VOIP40/50: Pres to show the contact list/ To scroll through
contact list / calls in Skype window / adjust volume while
talking
The contacts are sorted by name. Press e.g. 5 and you will see
all contacts starting with J
Make or answer a call End or refuse a call
C (1) Press to clear any numbers you have entered for a call (2)
Press to switch between the tabs of the Skype software (3) During a
call you can press C to enable mute, press C again to disable
mute
6. Base station (for CMP-VOIP50 only): Press to activate hands
free function (Press and hold to register handset)
Speaker light:(1) During a call via the handset, after pressing
the hands free key, the speaker light will flash(2) The speaker
light will be on when hands free function is active, otherwise it
is offCharge light:(1) When the handsets battery is full, the light
will be on(2) When the handsets battery is empty, the light will
flash(3) When the handset is taken away from the base, the light is
off
Register Handset to the base
If the LCD shows , this indicates the handset has not registered
to the base. (1) Press and hold the C key on the handset (approx.3
seconds).
(2) Press and hold the hands free key (approx.3 seconds) until
the LCD shows . This indicates the handset has been registered to
the base.
Safety precautions: To reduce risk of electric shock, this
product should ONLY be opened by an authorized technician if
service is required. Disconnect the product from mains and other
equipment if a problem should occur.
Warranty:No guarantee or liability can be accepted for any
changes and modifications of the product or damage caused due to
incorrect use of this product.
ENGLISH INSTRUCTIONS
EN
