1  

From your Advisor homepage, select “Grower Management” in the green bar at the top of the screen. Once you are in Grower Management, select the grower and site that needs to be mapped. When the site is open, select the Mapping Tab. To begin the Mapping process, select “Map Site.”

After Map Site is selected a “Select a Shape” dropdown and a “Draw” button will appear to the left of the “Measure” option.

In the “Select a Shape” dropdown, there are options of three shape types to select.

• Polygon- allows you to draw squares or irregular shapes • Crop Circle- allows you to draw a crop circle around a field • Exclusion- allows you to exclude an area from a polygon or crop circle

o Note- Exclusions can only be drawn after a polygon or crop circle are drawn and before “Save/Approve” is selected

After the shape that needs to be drawn is selected, select “Draw” to start drawing the shape. Click around the edge of the field to draw the field border. The field border should appear in yellow. The word “Finish” will appear when you are about to complete the Polygon or Crop Circle. Note: When draw is selected, the “Draw” button will be greyed out.

Mapping in Agrian

  2  

If an Exclusion needs to be drawn, change “Polygon” to “Exclusion,” then select “Draw.” The Draw button will be greyed out. Click around the area the exclusion is being drawn on. This line should start appearing in red.

After field boundaries and exclusions (when applicable) are completed, select “Save/Approve” to complete the map. This will bring up “Saving Changes” over the map. Once this is gone, the map has been saved.