Mark Powell

Address: 15 Calandra Avenue

Quakers Hill NSW 2763

Mobile: 0413 347 583

Email: jmpowell78@hotmail.com

Qualifications

City & Guilds Part One Electrical Installation Competencies

City & Guilds Part Two Electrical Installation Competencies

City & Guilds Supplementary Studies in Electrical Installation Competencies in Electronic

City & Guilds Electrical Installation Work Course C

Completion of Fibre Installation & Testing Multimode

ASCO4311 Australian Certificate

Occupational Health & Safety

ACA Open Registration Licence (formerly Austel) (Registration # P4476)

Elevating Work Platform Licence

Electrical Contractors Licence

Employment History

February 2013 – Present

Electrical Lift Mechanic – Otis Elevators – Western Sydney

Suburban truck service run;

Duties consisted of:

Service maintenance and breakdown call outs;

Liaising with customers and building managers;

MRL installations. Otis Gen 2 as well as foreign equipment, including Kone, Monospace,

Schindler, 300P, Thyssenkrupp and Boral;

Single and two speed AC relay logic installations;

Hydraulic installations, Otis 120M and various foreign installations;

Installation of small T projects;

Covering fringe night calls.

January 2007 – February 2013

Electrical Lift Mechanic – Otis Elevators – Sydney CBD

Duties consist of:

Services in VIP department;

Experienced in repair, modernisation and service;

Experienced in resolves 10s, 20s, 100s, TMS 5000, Monospace, EPL and Hydraulic;

Elevonic 401, 411, 413, 320, 420 and various foreign equipment;

Extensive knowledge of escalators and walkways;

Extra low voltage 12 volt, 32 volt, 100 volt DC wiring and equipment;

Low voltage 240 VAC and 415 VAC;

Installing and wiring main switchboards – utilising thermoplastic insulated and sheathed

flat cables;

Lift motors (AC and DC) and control encoders – utilising armoured and special cabling;

Earthing all equipment and metallic supports;

Continuity of earthing system in equipment, troughing and metallic conduits;

Installing and fitting buttons, safety and limit switches and hall lanterns; wiring locks in

shaft;

Wiring travelling cables, communication equipment, intercoms and alarms;

Installing, fitting and wiring lift cars operating panels, safety circuits;

Door motor and door motor controls;

Installation of heaters in hydraulic tanks;

Lift car and pit light and power; lift shaft lighting and hand lamps;

Fans and alarms; fire service lifts;

Commissioning lift equipment to AS1735 and EN81;

Verification and electrical compliance testing to AS/NZ 3000;

Maintaining and repairing electrical apparatus and circuits;

Diagnosing and rectification of electrical faults in electrical apparatus and circuits; and

Commissioning of electrical apparatus and circuits.

July 2006 – January 2007

Lane Cove Tunnel Project – United Group

Duties consisted of termination and installation of:

Run mains supply cables;

Sub circuits;

Data and control wiring; and

Installation of all cable trays and tunnel lighting.

November 2005 – July 2006

Electrician – Various Sub-Contracts involving commercial fitout installations in Sydney

CBD

Duties consisted of termination and installation of power, lighting and data/phones.

January 2002 – November 2005

Electrician (Modernisation Department) Kone Elevators

Duties consisted of termination and installation of:

Installation and leading hand;

Installation of low and medium rise lift systems;

Resolve 100s/resolve 10s/resolve 20s and resolve MX machines; and

Tendered repair work.

December 2001 – January 2002

Electrician – Somerville Group, Sydney

Duties consisted of termination and installation of:

Lighting circuits, general, emergency, fixtures and fittings;

Power sub-circuits; and

Data cables.

September 2001 – December 2001

M5 Tunnel Project – Heyday Group

Duties consisted of termination and installation of:

Lighting circuits, general, emergency, fixtures and fittings;

Power sub-mains, sub-circuits; and

Control, jet fan in 240v/415v.

Also, the installation of cable trays, cable enclosures and switchboards.

June 2001 – August 2001

Electrician – O’Donnell Griffin – Sydney Airport

Duties consisted of termination and installation of:

Lighting circuits, general, emergency, fixtures and fittings;

Control and power circuits.

January 1999 – December 2000

Electrician – Relabond Limited, UK

Duties consisted of:

Lighting circuits, general, emergency, fixtures and fittings;

Power sub circuits; and

Data cables.

December 1997 – December 1998

I spent a year travelling around Australia. During this time, I completed two contract jobs for

Rotric Pty and Electdata.

References can be obtained upon request.