Apply Sensor

Pair Radius PPG

1

2

3

Setup Instructions

G E T T O K N O W Y O U R S Y S T E M

see back for sensor application

SensorWorn on your wrist and fingertip,the sensor collects your data.

Snapped into the wrist portionof the sensor, the chip sends yourdata to the Masimo SafetyNet App.

Chip

Masimo SafetyNet displays Oxygen Saturation,Pulse Rate, Respiration Rate and other data fromRadius PPG. It also allows data updates to yourcare provider.

Masimo SafetyNet App

Radius PPG

Accept Masimo SafetyNetInvitation

See instructions on the backshowing how to apply the sensorto your wrist and fingerand insert the chip.

The invite will come to your email.After you accept, download theMasimo SafetyNet App and followsetup instructions.

page 1 of 2

Getting StartedMasimo SafetyNet™

Warning: Do not self-diagnose or self-medicate on the basis of themeasurements. Always consult your doctor.

Under Masimo SafetyNet AppSettings, enter the Add Devicemenu, and follow instructionsfor pairing the Radius PPG toyour phone.

For more info go to:masimo.com/masimo-safetynet

301295/10689B-0320

Masimo Safetynet | Build 1.0.0.0

2.1 Sensor Set UpHow to Apply your Sensor

2.2 Apply Finger Sensor

2.3 Insert Chip

3. Place sensor on wrist as shown and carefully thread the tip of the strap through the open red loop

4. Wrap the loose end of the strap around your wrist and press

1. Remove sensor from pouch 2. Peel off yellow label to activate battery

Listen for click to secure.

Look for lightto confirmconnection.

1. Insert the chip into the open compartment on the sensor

2. Press down on the chip to secure

page 2 of 2

Place blacksquare ( )on finger pad

1. Remove part of release liner and place star ( ) on top of fingernail of ring finger

2. Wrap halfway around finger. Make sure the star and square are lined up directly across from each other

4. Remove release liner and continue to wrap remainder around finger

3. Squeeze top and bottom of wrap to secure

5. Adjust cable to comfortable length