Embed Size (px)
Citation preview
You must be 18 yrs of age to purchase. We advise that all parts purchased from our inventory be installed and inspected by a qualified gunsmith. Modifying your weapon may be prohibited in your state. Do not modify your sear or hammer engagement surfaces. Before installing please be sure to check all local state and federal laws. By installing this part you agree to take full responsibility for any and all legal, health and warranty consequences that may be incurred.
Download or Print Instructions | Contact: [email protected] | Page 1
Step 1: Clear your Firearm - Check the Chamber, Bolt Face and Magazine Well.
Step 2: Gather Parts and Tools needed for Installation.
1. Micro-Tip Flathead Screwdriver
2. Hammer3. MCARBO CZ 75
Extra Power Recoil Spring
4. MCARBO CZ 75 Stainless Steel Guide Rod
5. Eye Protection
3.
Step 3: Pull the Slide back and Line up the Two Tick Marks near the Back of the Frame.
Step 4: Use your Hammer to Tap out the Slide Stop from the Back. Then Pop Off the Slide Stop with your Micro-Tip.
4.
1.2.
M*CARBO CZ 75 SP-01 Stainless Steel Guide Rod and Extra Power Recoil Spring
You must be 18 yrs of age to purchase. We advise that all parts purchased from our inventory be installed and inspected by a qualified gunsmith. Modifying your weapon may be prohibited in your state. Do not modify your sear or hammer engagement surfaces. Before installing please be sure to check all local state and federal laws. By installing this part you agree to take full responsibility for any and all legal, health and warranty consequences that may be incurred.
Download or Print Instructions | Contact: [email protected] | Page 2
Step 5: Separate the Slide from the Frame.
Step 6: Compress and Remove the Guide Rod and Recoil Spring Step 8: Open your New Stainless Steel Guide Rod and Recoil Spring
Step 7: Remove the Factory Guide Rod from the Recoil Spring.
M*CARBO CZ 75 SP-01 Stainless Steel Guide Rod and Extra Power Recoil Spring
You must be 18 yrs of age to purchase. We advise that all parts purchased from our inventory be installed and inspected by a qualified gunsmith. Modifying your weapon may be prohibited in your state. Do not modify your sear or hammer engagement surfaces. Before installing please be sure to check all local state and federal laws. By installing this part you agree to take full responsibility for any and all legal, health and warranty consequences that may be incurred.
Download or Print Instructions | Contact: [email protected] | Page 3
Step 9: Insert the New Stainless Steel Guide Rod into the Recoil Spring.
Step 10: Compress the Recoil Spring and Guide Rod back into the Slide. Make sure the Rod is lined up with the Front Hole.
Step 11: Re-Attach the Slide to the Frame. Line up the Notches in the back again.
Step 12: Insert your Slide Stop and Snap it into Place.
M*CARBO CZ 75 SP-01 Stainless Steel Guide Rod and Extra Power Recoil Spring
You must be 18 yrs of age to purchase. We advise that all parts purchased from our inventory be installed and inspected by a qualified gunsmith. Modifying your weapon may be prohibited in your state. Do not modify your sear or hammer engagement surfaces. Before installing please be sure to check all local state and federal laws. By installing this part you agree to take full responsibility for any and all legal, health and warranty consequences that may be incurred.
Download or Print Instructions | Contact: [email protected] | Page 4
That’s it! Check your Slide Stop Function and Trigger Pull and you’re Good to Go!
M*CARBO CZ 75 SP-01 Stainless Steel Guide Rod and Extra Power Recoil Spring
