Microsized

Lap Dog TrainerAdvanced features help develop good household habits quickly

Great for dogs big and small

WE CARE. CALL US FIRST. 1-800-826-5527LIMITED LIFETIME WARRANTY

Invisible Technologies warrants to the original retail purchaser, that Innotek brand products will be free from defects in material and work-manship, under normal use, for a period of one year from the date of the original retail purchase. This Limited Warranty excludes: accidentaldamage due to dog chews; lightning damage where an INNOTEK lightning protection component is not in use (in-ground pet fencing sys-tems); or neglect, alteration and misuse.

Invisible Technologies offers several product exchange options during the warranty period. If service is required, call 1-800-826-5527 to dis-cuss the service plan that best serves your needs. Costs are dependent on the processing time and the desired shipping options. Please donot return this product to your retailer.

After one year from date of original retail purchase, we will repair, replace or upgrade your product at a fixed rate based on the component.

Invisible Technologies, Inc., shall not be liable or responsible for any incidental or consequential damages resulting from the use of the prod-uct or caused by any defect, failure or malfunction of the product, whether a claim is based upon warranty, contract, negligence or otherwise.

Extended wear may cause skin irritation. Refer to owner's guide.

Advanced features help develop goodbehavior quickly in dogs big and small.

This featherweight collar receiver rests easily on your dog’s neck. Innovativein-set contact probes precisely fit the small necks of toy and other small "lap

dog" breeds. Optional wide set probes for larger dogs are included. This systemalso features tone-only training options, for greater training flexibility.

7 62964 18138 5

2400268-1

Microsized

Lap Dog Trainer

System Includes:• Miniature, featherweight collar receiver – • Optional in-set contact probes for

smallest on the market today thinner neck sizes• Compact, lightweight, six-button • 4 levels of stimulation, instantly

transmitter available• Options for GOOD and BAD tone-only • Range to 200 feet

training – no stimulation required • Test light• All batteries included • Introduction to Dog Training DVD• FREE Professional Training Support • Limited Lifetime Warranty

Thread the included collar strap through the channelson the receiver. With the collar turned OFF, place ondog and adjust to fit. The collar fit should be snug, yetloose enough to allow one finger to fit between thestrap and the dog’s neck. Fit is important because aloose collar may cause inconsistent performance. It’sokay to trim any excess strap length.

Understanding the TransmitterThe handheld device signals the collar receiver toproduce stimulation and/or tone. The transmitter iswater-resistant and should not be immersed in wateror placed in a dishwasher.

Transmitter Buttons:1-LOW to 4-HIGH. – Select any of 4 stimulation lev-els instantly. We recommend that you always starttraining your dog with the lowest stimulation, andincrease to a higher level if necessary. You will knowwhen you’ve reached the right level when your dogresponds by twitching his head, neck or shoulders orby perking up his ears. If the dog vocalizes, you needto go to a lower level.

You control the length of the stimulation by how longyou press the button. For a short stimulation, pressand release the button. For a longer stimulation, holdthe button down. A maximum of 10 seconds may beapplied before the safety feature to prevent over-cor-rection engages. After 10 seconds, stimulation will belocked out for another 10 seconds. During the lock-out period a solid tone will sound.

GOOD Tone ButtonSimply press the GOOD tone button when your dogdoes something good and follow up immediately witha favorite treat and plenty of praise. Your dog willquickly learn to associate the GOOD tone with prop-er behavior.

BAD Tone ButtonThe BAD tone followed by the stimulation is used forinappropriate behavior. Your dog will quickly learn toassociate the BAD tone with inappropriate behavior.You can then use the BAD tone alone to discouragemisbehaviors.

PROGRAM – used in tandem with buttons on thetransmitter face to change ID Codes or set tone-with-correction options.

Your transmitter has an LED light:• Pulsating green light – unit is transmitting• Pulsating red light – low battery

Changing the ID CodeThe SD-70 offers 2,048 ID codes in case you experi-ence problems from other nearby training units. Tochange codes:

• Turn the collar off.• Press and hold the PROGRAM button on the backof the transmitter.• Continue pressing PROGRAM, while pressing 1-LOW on the face of the transmitter.• Release only the PROGRAM button, while continu-ing to press 1-LOW.• When the LED ceases flashing red-green, release1-LOW.

Step 1Fit Collar on Dog

SD-70 Lap Dog TrainerQuick Start Guide

Step 2Power Up

Transmitter: Insert 12v alkaline battery in the trans-mitter positive (+) side out. Replace metal cap.

Receiver: Your receiver comes ready to go with bat-teries installed. Activate the collar by turning thereceiver’s battery cover clockwise to the ON position.

Step 3Match Components

Press GOOD Tone button on the transmitter within30 seconds of turning ON the receiver. The compo-nents now work together.

You may wish to set tone mode before working withyour dog. See "Setting/Changing the tone mode."

When not in use, be sure to turn the receiver OF toextend battery life.

• Rematch the components as shown in Quick StartStep 2.

Setting/Changing the Tone ModeYour can set the SD-70 to deliver the BAD tone auto-matically when you push a stimulation button. Threesettings are possible – tone with the stimulation, tonefollowed by delayed stimulation or stimulation only.

1. Press and hold the PROGRAM button on the backof the transmitter.2. Press and hold one of the following to select thetone option:

• BUTTON 2 for tone ON with stimulation• BUTTON 3 for tone OFF with stimulation• BUTTON 4 for tone with a one-second delay

before stimulation 3. While continuing to hold BUTTON 2, 3, or 4,release the PROGRAM button. The transmitter lightwill stay solid for a couple of seconds, and then goout.4. As soon as the solid light goes out, release BUT-TON 2, 3, or 4.

Understanding the ReceiverThe collar receiver produces stimulation and/or tone.The receiver is water-resistant and should not beimmersed in water or placed in a dishwasher.

Testing the ReceiverYou may wish to test the collar from time to time. Totest:

• Hold the test light provided across the receiver’sposts• Press a stimulation button 1-LOW to 4-HIGH.• Test light will illuminate.• The intensity of the test light will increase as thelevel increases.

Replacing BatteriesTo replace batteries, twist the battery cover counter-clockwise, to the OPEN position. Lift the cap out,remove old batteries and insert new batteries withpositive (+) side down toward the battery cap lid.

Changing PostsYour SD-70 receivercomes with innovativeinset probes designedto precisely fit thesmaller necks of toyand lap-dog breeds.

To change the posts to the in-set design, simplyremove the contact posts, then assemble the in-setposts using the Phillips head screws provided (seeillustration). Be sure that the post base lifts up andaway from the battery cap on/off switch.

ON

OFF

OPE

N

Replacement batteries:Your SD-70 transmitter uses a 12-volt alkaline battery, and the receiver uses two 3-volt Lithium coin cell batteries (CR-2032). These are commonly available where youbought your training system, or where batteries are sold.

Compliance with U.S. Telecommunications RegulationsThis Innotek Remote Training System is designed to meet requirements set forth byUnited States country telecommunications authorities. Note that in some countries,use may be limited due to national frequency planning requirements. The user isresponsible for respecting those rules.

Training TipsWatch the included DVD to get the basics for training your dog properly with a remotetrainer.

Always praise your dog for good behavior!

Teach him what the commands mean before introducing the collar as a reinforcementtool.

Keep training sessions brief, about ten minutes of training and then a rest or playperiod of at least equal length.

Dogs learn through repetition. You may have better training success if you can elicitan undesired behavior when you can anticipate it. For example, if the dog misbehavesand jumps on visitors, have someone come in and out of the front door several timesover a half-hour period. You'll be expecting it and will be ready to teach your dog theright behavior.

Always end a training session on a positive note. Let the dog have success. This wayhe'll look forward to the next session.

Training should be fun for both you and your dog. Never train when you are angry. Ifyou get frustrated during training, stop and come back to it later. Your dog will learnbetter when you are both relaxed.

We recommend your dog be at least six months old before starting a remote trainingprogram. You will be asking your dog to concentrate for periods of time and to remem-ber what you have taught. Young puppies do not necessarily have the required mentaldevelopment or attention span for these activities.

The goal of training is to condition your dog to respond to your verbal commandunder all situations. You should plan on using the collar for at least four months. Agood rule is, once started with a remote trainer, to regularly have the collar on whenyou take the dog out. This will ensure that he will always be imprinted with the correctresponse to your commands and that you are always in control.

Take advantage of the FREE Professional Training Support that comes with yourInnotek remote trainer purchase.

Register Your Product:Your product can be registered on our website atwww.innotek.net

TroubleshootingIf the collar appears not to be working, try the following:

• Adjust the collar strap to fit.• Test the receiver with the test light. If no light, replace the battery.• If the transmitter LED is out, replace the transmitter battery.• Rematch the components as shown in the Quick Start Guide.• Check that the probes are tightened and are the correct spacing.• Ensure that the probes are touching the dog’s skin.• If necessary, trim the dog's hair to ensure proper skin contact. Never shave thedog’s neck.• Use a stronger stimulation level.

If you cannot solve the problem by following these steps, please call 1-800-826-5527.

IMPORTANT ADVICE1. Read the complete manual and follow all directions. If you have any questions, pleasecall 1-800-826-5527.

2. This device is intended for use only on dogs. Never attempt to use it for any purposenot described in this manual.

3. Never perform set-up procedures while the collar is on your dog.

4. Any collar worn for extended periods can cause a condition similar to bedsores, knownas Pressure Necrosis. To reduce the possibility, you must do the following:

• Never leave the collar on the dog for more than 12 consecutive hours.

• Examine the dog’s neck daily for any signs of a rash or a sore.

• Supervise your dog during the first 2 days of training.

• Check the fit to prevent excessive pressure; you should be able to insert one fingerbetween the collar strap and your dog’s skin.

• Wash the dog’s neck area and the probes of the collar weekly with a wash cloth.

• If the condition persists beyond 24 hours, see your veterinarian.

5. Do not attempt to dismantle or repair any components of this system; doing so will voidthe warranty in full. The computerized circuitry should be serviced only by an authorizedexpert.

6. Realize that because dogs have unique temperaments, there is no way of knowing howyour dog will react to the introduction of a training collar system. For the safety of yourdog, a long lead should be used during initial training so you have control of the situation.

7. If you have reason to believe that your dog may pose a danger to others, harm itself,or react adversely to the collar, do not rely solely on this product to train your dog. If yourdog shows signs of growling, snarling or biting while using the collar, stop immediately.Aggression in dogs has many causes. We recommend that you consult a knowledgeableprofessional dog trainer or animal behaviorist with experience with aggressive dogs if yourdog has shown any of these characteristics.

8. Occasionally, a dog cannot be trained to respond to a training collar. Sometimes evena properly trained dog may disobey a command. Therefore, Invisible Technologies, its dis-tributors, and dealers cannot guarantee that the system will in all cases keep the cus-tomer’s animal from disobeying commands.

FREE Professional Training SupportAdditional behavior or training issues? Looking for the best way to

get a well-behaved dog? Just call our FREE Professional Training Support hotline at800-364-3362 and speak with the professionals

at Dogstar Training.

Visit www.partnersinbehavior.com

Innotek, the Innotek logo, and Free Spirit are registered trademarks of Invisible Technologies, Inc.All other product and service names are the property of their respective owners.

© 2004, Invisible Technologies, Inc.All rights reserved

Invisible Technologies, Inc.1-800-826-5527www.innotek.net