Embed Size (px)
DESCRIPTION
MILK PLATE PASTEURIZER. MILK PLATE PASTEURIZER Milk pasteurizer for instance the following thermal cycle 4-75-4 or other, in relation with the product to handle. The plant will be composed as follow: *Buffer tank for milk m ade in AISI 304 stainless steel, with the following characteristics: - PowerPoint PPT Presentation
Citation preview
MILK PLATE PASTEURIZER
MILK PLATE PASTEURIZER
Milk pasteurizer for instance the following thermal cycle 4-75-4 or other, in relation with the product to handle.The plant will be composed as follow:*Buffer tank for milk made in AISI 304 stainless steel, with the following characteristics:- AISI 304 stainless steel tank, with glazed and pickled inside and outside surface- Pickled, flattened, grounded and spotted welding- Conical bottom with total exhaust valve - Plate cover with CIP (cleaning in place) devices.- Total discharging piping, manufactured in stainless steel- Glass level rod, with stainless steel protection.- level sensor to stop /start the pump-three legs supporting structure manufactured in stainless steel*Milk centrifugal pump with sanitary close impeller manufactured in stainless steel AISI 304, connection DN 25. *Plate pasteurizer designed for the treatment milk. Thermal cycle 4-75-4°C or different if it is necessary. The pasteurization section is composed of an heating section from 4°C to 50°C using product in counter flow, a pasteurisation section from 50 to 75 with hot water at 90°C, a precooling product section from 75 to 30°C with product in counterflow (heating recovery system) and a cooling section from 30 to 4°C with ice cold water at +2°C. The exchanger is composed of:-plates in stainless steel AISI 316 and nitrile alimentary rubber joints -intermediate plates in stainless steel AISI 304-frame in stainless steel AISI 304 with closing lateral tie rod-pipe connections for various fluids in stainless steel-thermal holding system with multiple pipes. The pipes are connected in serial with detachable turns and mounted on a supporting frame in stainless steel.-hot water at 90°C adjustable group formed by an heat exchanger pump, an expansion tank pipes automatic temperature control-steam group formed by a manual valve, pneumatic valve, steam filter and condensate discarging group-chilled water at +2°C adjustable group formed by a pneumatic valve, pipes, and manual valve and chiller
-Instruments to record the pasteurising and the exit temperature-System to adjust the thermal fluid temperatures-3 ways valve to divert the product in case of low temperature-Necessary electro pneumatical transducers-PT 100 probes for temperature measurements- Air reducing equipment for compressed air*Electrical control board including: electronic temperature regulator with PID control, main circuit breaker, work/ wash selector switch, pump selector switches
TECMON S.R.L. P.IVA 00791710965VIA LEONARDO DA VINCI, 11/B COD.FISC. 0482120015320060 CASSINA DE’ PECCHI (MI)TEL. +39 0295299106 CAP. SOC. € 83.000,00 INT. VERS.FAX +39 0295299315 ISCR. TRIB. DI MONZA REG. SOC. 17929E-MAIL : [email protected] C.C.I.A.A. MONZA E BRIANZA 1041916E-MAIL : [email protected]:// www.tecmon.it
