Embed Size (px)
Citation preview
Keep this Product ID Number and use when contacting Customer Service:
OWNER’S MANUAL
MODEL N° 90086
OWNER’S MANUAL
COPY
2
Save this owner’s manual for future reference and in the event that the manufacturer has to be contacted.
REGISTER YOUR PRODUCT ONLINE AT WWW.LIFETIME.COM
At Lifetime, we are committed to providing innovative and quality products. While registering, you will
have the opportunity to give us your feedback. Your input is valuable to us.
Lifetime’s Promise to You:
REGISTER today!
**U.S. and Canada customers ONLY**
DO NOT CONTACT THE STORE!CALL OUR CUSTOMER SERVICE DEPARTMENT at
1 (800) 225-3865
Questions or Missing Parts? ID:
**For Assistance in Europe,**
Please contact:
LIFETIME EUROPE After Sales, Euro BaseIDA Industrial Estate, Cork Road Waterford, [email protected]
Or call:
00 800 85561360
INSTRUCTION #1070343 H 11/25/2014
COPY
3
Most injuries are caused by misuse and/or not following instructions. Use caution when using this product.
FAILURE TO FOLLOW THESE WARNINGS MAY RESULT IN SERIOUS INJURY OR PROPERTY
DAMAGE AND WILL VOID WARRANTY.
SAFETY INSTRUCTIONS
BEFORE BEGINNING ASSEMBLY
4
TOOLS AND PARTS REQUIRED FOR THIS ASSEMBLY
*Two adults required to
complete assembly*
Only adults should set up the product. Do not allow children
in the setup area until assembly is complete.
7/16” Wrench Pliers1/2” Wrench 3/8” Wrench
5
This area is located at the top,
left-hand corner of the page
and indicates which tools
and hardware are needed to
complete the assembly steps
on a page.
Note:!
Refer to the following areas throughout the instructions
to assist in the assembly process:
This area is usually located in the
bottom, left-hand corner of a step
and indicates that special attention
is needed to perform a particular
part of a step.
These areas are usually located in
the bottom, right-hand corner of a
step and indicate that damage to
the product or serious injury may
occur if the caution or warning is
not heeded. WARNING
ASSEMBLY GUIDES
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
CAUTION
6
PARTS LIST
HARDWARE LISTID Item Description Qty
ID Item Description Qty
! Mounting Kit Not Included
7
BACKBOARD TO RIM ASSEMBLYSEC
1
HARDWARE REQUIRED
ADQABI
AJW
BNP
AAJ
ABDABF
ABK AAV
BCS
8
BACKBOARD TO RIM ASSEMBLYSEC
1
PARTS REQUIRED
ALX
Pliers 1/2” Wrench 7/16” Wrench
TOOLS REQUIRED
AJI
3/8” Wrench
AKZ
AOW
AOX
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
9
BNP
AAS
ABSAAB
7/16”
AAB
ABS
AAB
AAS
AAS
BNP
AJJ
AJK
Notch
BNP
AJJ
AJK
To ensure a good fit, use the
U-Bolt included with this system.
4.86” U-Bolt (BNP) Left and Right Backboard Brackets (AJJ
& AJK, Not Included)
THESE BACKBOARD BRACKETS ARE A PART OF THE MOUNTING KIT, AND ARE NOT
INCLUDED WITH THIS SYSTEM. SEE STEP 1.9 FOR DETAILS.
SEC
1.1
1/4” x 2 3/4”
Hex Bolts (AAS) 1/2” x 2 5/16” Galvanized Spacers (ABS) 1/4”
Centerlock Nuts (AAB)
THIS HARDWARE IS ALL CONTAINED IN THE MOUNTING KIT, AND IS NOT INCLUDED
WITH THIS SYSTEM.
SEC
1.2
! The Mounting Kit hardware, shown above,
is not included.
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
10
AAJ ABD ABF
ABF ABF
AAJ
ABG ABD ABF
ALX
5/16” x 2 1/4” Tap Bolts (ABG) 5/16” Washers (ABD)
7/16” Rubber Washers (ABF) Rim
(ALX) 5/16” Hex T-Nuts (AAJ)
SEC
1.3
Note: Do not overtighten the hardware so that the 7/16” Rubber
Washers bulge outward as shown.!
Note: Make sure that the 5/16” x 2 1/4” Tap Bolts are
positioned on the outside edge of the holes as shown.!
CorrectIncorrect
ABG
ABG
AAJAAJ
ALX
ABG
1/2”
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
11
Rim Support Channel (AOX)
Backboard (AJI)
4.86” U-Bolt (BNP)
SEC
1.4
Rim (ALX) Backboard (AJI)
5/16” Jam Nuts (AAV) 4.86” U-Bolt (BNP)
5/16” Flanged Nylock Nuts
(ABK) 5/16” x 2 1/4” Tap Bolts (ABI)
SEC
1.5
ABKAAV
AJI BNP
BNP
AAVAAV
ALX
AJI
ABI
AOX
AOX
ABK ABK
1/2”
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
12
1/2”
ABK
AJWAOW
Compression Springs (AJW) 4.86” U-Bolt (BNP)
Spring Retainer Plate (AOW)
5/16” Flanged Nylock Nuts (ABK) Rim (ALX)
SEC
1.6
Note: DO NOT COMPLETELY TIGHTEN THE 5/16” FLANGED NYLOCK NUTS IN
THIS STEP! Only tighten the Nuts until the Rim does not wobble. Tightening
the Nuts will adjust the Rim tension.!
ABK
AOW
AJW
BNP
ALX
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
13
Left and Right Backboard Brackets (AJJ & AJK)
Backboard (AJI)
SEC
1.7
ADQADQ
3/8”
AJJ AJK
AJI
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
14
SEC
1.8
ALX
AKZ
Net (AKZ) Rim (ALX)
Note: If a replacement Net is needed, please call our Customer Service Department.
Our Nets are shorter than average to reduce the risk of entanglement.!
NO TOOLS OR HARDWARE REQUIRED FOR THIS PAGE
15
Model #9594
Please see the next page for ordering information.
FIG. A, ROOF MOUNT FIG. B, WALL MOUNT
ROOF MOUNT, WALL MOUNT, EXISTING POLE MOUNT
SEC
1.9
FIG. C, EXISTING POLE MOUNT
! Mounting Kit Not Included
16
PRODUCT DESCRIPTION MODEL #
AVAILABLE ACCESSORIES
SEC
1.10
®
Cleaning and Care
CLEANING & CARE
LIFETIME PRODUCTS, INC.
P.O. BOX 160010
BLDG. D-11, FREEPORT CENTER
CLEARFIELD, UT 84016-0010
17
ENHANCE YOUR LIFETIME® PURCHASE BY ADDING
ACCESSORIES OR OTHER GREAT PRODUCTS:
Or call: 1-800-424-3865
To purchase accessories or other Lifetime Products, visit us at:
www.lifetime.com
18
FAUTE DE NE PAS SUIVRE CES AVERTISSEMENTS, VOUS RISQUEZ DE CAUSER DES BLES-
SURES GRAVES ET/OU DES DOMMAGES À L’ÉQUIPEMENT.
SI NO SE OBEDECEN ESTAS ADVERTENCIAS PUEDEN PRODUCIRSE GRAVES LESIONES Y/O
DAÑOS A LA PROPIEDAD.
FAILURE TO FOLLOW THESE WARNINGS MAY RESULT IN SERIOUS INJURY AND/OR
PROPERTY DAMAGE.
#FS16400 10/12/2004 www.lifetime.com
WARNING
ADVERTENCIA AVERTISSEMENT
19
NOTES
20
LIFETIME BASKETBALL EQUIPMENT5-YEAR LIMITED FACTORY WARRANTY
THE MANUFACTURER RESERVES THE RIGHT TO MAKE SUBSTITUTIONS TO WARRANTY CLAIMS IF PARTS ARE
UNAVAILABLE OR OBSOLETE.
ALL WARRANTY CLAIMS MUST BE ACCOMPANIED BY A SALES RECEIPT.
REPORT PRODUCT DEFECTS IN WRITING TO:
To register the product, visit our Web site at www.lifetime.com
WARRANTY INFORMATION
www.lifetime.com
