Mounting System Matrix: Flat Roof Systems

Plan your project with our mounting systems in K2 Base or K2 Base On

Membrane, bitumen, gravel, green roofs

Trapezoidal Sheet Metal

Mounting system S-Dome S-Dome V D-Dome D-Dome V

Image, orientation, scope of application

Roof fi xation Ballast *1 Screws *2 Ballast *1 Ballast *1 Screws *2 Ballast *1

Module inclination 10° 10° 10° 10°

Features T Suitable for fastening low-load systems to con-tinuous rails T S-Dome 2.0 short rail system option available

T Short mounting rails with an integrated ballast tray T Flexible EPDM support pad:

∙Compensates for tolerances ∙Better friction coeffi cient reduces ballasting

T Suitable for fastening low-load systems to con-tinuous rails T D-Dome 2.0 short rail system option available

T Short mounting rails with an integrated ballast tray T Flexible EPDM support pad:

∙Compensates for tolerances ∙Better friction coeffi cient reduces ballasting

Technical assessment T Wind tunnel tested T Structural verifi cation

T Wind tunnel tested T Structural verifi cation

T Wind tunnel tested T Structural verifi cation

T Wind tunnel tested T Structural verifi cation

Module orientation

Module length 1386 - 2067 mm 1386-2067 mm 1386 -2080 mm 1386 - 2080 mm

Module width 950 - 1100 mm 990 -1002 mm 950 -1100 mm 990 -1002 mm

*1 Ensure ballast components are suitable according to technical design and product information.

*2 For roof mounting we recommend S-Dome or D-Dome Classic with continuous rails. When mounting on trapezoidal sheet metal, k2 Systems structural design must be followed!

Mounting System Matrix: Flat Roof Systems

Plan your project with our mounting systems in K2 Base or K2 Base On

Membrane, bitumen, gravel, green roofs

Trapezoidal Sheet Metal

Mounting system S-Rock Triangle MultiAngle

Image, orientation, scope of application

Roof fi xation Ballast *1 Ballast *1 Screws *2 Ballast *1 Screws *2

Module inclination 15° 10 - 45° 10°, 15°, 20°, 25°, 30°, 35°, 40°

Features T Components with integrated ballast T Optimal for quick installation

Individually customised elevation offering high fl exibility

Individually customised elevation with preset inclination angles

Technical assessment T Wind tunnel tested T Structural verifi cation

- -

Module orientation

Module length 1638 - 2067 mm custom length custom length

Module width 982 - 1001 mm custom width custom width

*1 Ensure ballast components are suitable according to technical design and product information.

*2 For roof mounting we recommend S-Dome or D-Dome Classic with continuous rails. When mounting on trapezoidal sheet metal, k2 Systems structural design must be followed!