CLEAN UPPER AND LOWER MUD PRESS SHOWERS

STEPS / ACTIONS SAFETY & QUALITY PICTURES & DIAGRAMSREDUCE WATER FLOW TO LOWER MUD PRESS SHOWER BARBelow the mud press water T junction is a red lever tap. Close the tap off until the water is only trickling from the shower holes.

OPEN SHOWER BAR DRAIN TAPWalk around to the back of the mud press with the bottle brush rod.Fully open the shower bar release tap.

Do not stand directly in line with the end of the tap as water may quickly exit shower bar, soaking you.

CLEAN INSIDE SHOWER BARInsert the bottle brush rod into the shower bar.Move brush in and out of shower bar in an attempt to remove any build up on the inside of the bar.

Again, do not stand directly in line with the end of the tap as water may quickly exit shower bar, soaking you.

CLEAN UPPER AND LOWER MUD PRESS SHOWERS (cont.)

STEPS / ACTIONS SAFETY & QUALITY PICTURES & DIAGRAMSALLOW BUILD UP TO DRAIN Remove brush from inside the bar. Allow some time for the water to flush the build up out of the

inside of the bar.CLOSE RELEASE TAP Once all build up has been washed out of the bar, fully close the

release tap. Double check that tap is closed correctly.

OPEN LOWER SHOWER BAR INLET WATERBelow the mud press water T junction is a red lever tap. Fully open the tap to allow full pressure water to pass into the shower bar.

CLEAN UPPER AND LOWER MUD PRESS SHOWERS (cont)

STEPS / ACTIONS SAFETY & QUALITY PICTURES & DIAGRAMSCLEAN UPPER SHOWER BARFollow the same procedure for lower shower.Inlet tap is mounted to the right of the T junction.Climb ladder and follow same procedures as for lower shower bar.

Do not stand directly in line with the end of the tap as water may quickly exit shower bar, soaking you.