-
HERCULESNANO
3.5 CHANNEL IR HELICOPTER
AGES 8+
INSTRUCTION MANUAL
ITEM NO. 35939
-
• Be sure that Helicopter Battery is fully charged and Remote
Control Batteries are fresh.• Helicopter will fly best in low wind
conditions. • Fly Helicopter in a wide open area with no people,
pets, and other objects in the way.• Do not fly in strong winds.
This will make operation difficult and crash the Helicopter.
1: Parental Guidance is suggested for children operating
Helicopter.2: Multiple Helicopters operating simultaneously must be
on different Frequency Bands.
HERCULES
• Unscrew cover and install 6x AA Batteries as shown.• Please
note polarity and orientation of batteries.
REMOTE CONTROL TRANSMITTER
PREFLIGHT CONDITIONS
BATTERY INSTALLATION
THROTTLE
CHANNEL SELECTOR
LIGHT BUTTONINFRARED EMITTER
TURBO BUTTON
FORWARD/BACKWARD/LEFT TURN/RIGHT TURN
POWER SWITCHTRIM KNOB
-
UP DOWN
FORWARD BACKWARD
TURN LEFT TURN RIGHT
HELICOPTER TAKEOFF
FLIGHT CONTROLS
1: Place Helicopter on a flat surface. Turn on the Transmitter
and the Helicopter 2: Check surroundings to be sure that it is
clear of people, animals, and obstructions.3: Slowly push the
Throttle Stick up to increase blade speed for lift.4: Adjust
throttle input to maintain a steady hover.
The Left and Right Sticks will move the helicopter as
follows:
-
If the Helicopter spins to the left or right in flight without
your input, you willneed to adjust the trim.
Switch betweenHigh & Low SpeedModes
LIGHTBUTTON
Helicopter spins to the left. Slowly twist the trim knob to the
right until the helicopter stops spinning.
Helicopter spins to the right. Slowly twist the trim knob to the
left until the helicopter stops spinning.
ADJUSTMENTS
CHARGING
TROUBLESHOOTING
1: Helicopter can be charged from: USB, Controller, or AC
Charger2: Move the Helicopter Power Switch to the OFF position 3:
Connect Charging Adapter to Helicopter Charge Port.4: Once charging
is complete, disconnect Charging Plug from Helicopter.5: Helicopter
is ready for flight.
USB CONTROLLER
The Transmitter indicator LED does not work
No controlof the helicopter
Helicopter isnot flying highenough
Batteries installed with the wrong polarity.
Point Transmitter at Helicopter or operate in conditionswith
less sunlight.
Helicopter is not IR receiving signal fromtransmitter.
Test the control functions of the helicopter in a hover by
applying light throttle and testing left and right controls.
Helicopter is not receiving signal fromtransmitter
correctly.
Push Left Control Stick up for more rotor speed.Rotor speed is
too slow.
Fully charge helicopter before use.Batteries are drained.
Fly helicopter in calm conditions. Windy Conditions.
Check the polarity of the batteries and install
themCorrectly.
Batteries are drained. Install new batteries.
-
Website: www.worldtechtoys.comEmail:
[email protected]: (877) 498-8697 Monday - Friday
/ 9:00AM - 5:00PM / Pacific Time
WWW.WORLDTECHTOYS.COM
MADE IN CHINA
SPECIFICATIONS, COLORS AND CONTENTMAY VARY FROM
ILLUSTRATIONS
ATTENTIONREAD THESE INSTRUCTIONS BEFORE OPERATING THE
HELICOPTER
- Install only new batteries of the same type in your
product.
- Failure to insert batteries in the correct polarity, as
indicated in the battery compartment, may shorten the life of the
batteries or cause batteries to leak.
- Do not mix old and new batteries.
- Do not mix Alkaline, Standard (Carbon-Zinc) or Rechargeable
(Nickel Cadmium) or (Nickel Metal Hydride) batteries.
- Do not dispose of batteries in fire.
- Batteries should be recycled or disposed of as per state and
local guidelines.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions.1) This device may not
cause harmful interference.2) This device must accept any
interference received, including interference that may cause
undesired operation.
