-1-

BEFORE YOU BEGINBEFORE YOU BEGIN

INSTALLATION INSTRUCTIONS

NATURA

WASHBASIN CABINETSK-15300T/K-12599T/K-15196T/K-12600T

�

�

�

�

�

�

�

Please read these instructions carefully to familiarizeyourself with the required tools, materials, and installationsequences. Follow the sections that pertain to yourparticular installation . This will help you avoid costlymistakes. In addition to proper installation, read alloperating and safety instructions.All information in these instructions is based upon thelatest product information available at the time ofpublication. Kohler China. reserves the right to makechanges in product characteristics, packaging, oravailability at any time without notice.These instructions contain important care, cleaning, andwarranty information-

Turn off the water supply.The pluming installation must comply with Water SupplyRegulations/Bye-laws, Building Regulations or anyparticular regulations and practices, specified by the localwater company or water undertakers. The installationshould be carried out by a plumber.Before installation carefully inspect the new fixture for anysigns of damage.

please leave instructions for theconsumer.Natura bathroom cabinet includes a series of washbasincabinet with visible surfaces of white and light maple/oakgrain. The series adopt E1 grade wood-based panel ofhigh quality, and with further processing, its harmfulemissions will be less than 1.5mg/L. Washbasin cabinetswith two doors and three doors are available.

�

�

�

�

�

�

�

-

/

E1

1.5mg/L

ORDERING INFORMATION

This installation covers the following products in the NATURArange:

NATURA 694mm Washbasin Cabinet.................K-15300TNATURA 694mm Washbasin Cabinet.................K-15196TWITH NATURA 850mm Synthetic top ...............K-15452TNATURA 1040mm Washbasin Cabinet...............K-12599TNATURA 1040mm Washbasin Cabinet...............K-12600TWITH NATURA 1050mm Synthetic top...............K-15453T

694mm .........................................K-694mm .........................................K-

850mm ..............................K-1040mm .......................................K-1040mm .......................................K-

1050mm ............................K-

15300T15196T15452T12599T12600T15453T

SAFETY: WARNINGS

Kohler products are precision-engineered and should givecontinued superior and safe performance, provided:

1. They are installed, commissioned, operated andmaintained in accordance with the recommendations givenin this Manual.

2. Periodic attention is given, as necessary, to maintain theproduct in good functional order. Recommendedguidelines are given in the section.

Carefully inspect the new fixture for any signs of damage.

When installing Kohler Products, manufacturers guidelines forpower tool safety should be followed.

MAINTENANCE

1.

2.

215500

, 2009

Copyright Kohler China Ltd., 20091082405-T01-C

Fig.11

ROUGHING-IN

INSTALLATION

-2-

UNIT : mm

15300T/15196T 694mmWashbasin Cabinet

(Not lnclude CountertopWashbasin Legs)( )

12599T/12600T 1040mmWashbasin Cabinet

(Not lnclude CountertopWashbasin Legs)( )

A. Install Washbasin Cabinet

Install the services.Hot (H) and Cold (C) inlets must be connected to the correctinlet pipes.Install the drain in accordance with the manufacturer sinstructions.We suggest using P-trap drain. Connect P-trap pipe withwashbasin drain.

Make sure a watertight seal exisits on allwashbasin drain connections.

Provide access to the plumbing connectionsfor future plumbing maintenance.

The hot and cold water supplies must be installed withisolating valves.

Caution!

Caution!

'

A.

(H) (C)

P

694

1040

1082405-T01-C

-3-

20

20

694

619

591

236

20 20

1040

619

!

Fig.22

Wall Bracket

UNIT : mm

1.1. Mark the position of hanged bracket according todimensions as illustrated, and loosen the suspension hookof washbasin cabinet.

Avoid the cables and pipes inner set when

drilling in the wall.

Note: Different types of bolts are required for differentdecoration boards. Please apply suitable bolts and board nuts.

Caution!

2004/12/6

Wall Bracket

1082405-T01-C

-4-

5.5. Hang the washbasin cabinet on the wall, and position the

suspension on the hanged bracket.

1 2

Fig.44

2.

3.

4.

2. Drill holes for fixing the bracket. Using a level, ensure thatthe hanged bracket is level.

3. Use suitable board nuts and bolts, and fix the hangedbracket on the wall.

4. Loosen bolts on the hinges of washbasin cabinet doorcarefully as illustrated, remove the washbasin cabinet doorcarefully and put it aside.

21

Fig.33

1082405-T01-C

-5-

Fig.55

6. Adjust all hinges of door in three-way as illustrated, andmake sure that the door is level and neat. Clearancebetween doors is even, and that between doors andcabinet is tight.

6.

7. Set the washbasin cabinet onto the wall bracket. Be sure

the cabinet adjusted level and the back board of cabinet

appressed to the wall by adjusting the screws of wall clips.

7.

8UNIT : mm

Fig.66

1082405-T01-C

8. Mark the wall through two holes at the correspondingpositions.

9. Dismount the washbasin cabinet and put aside. Drill holesat the marked position.

10. Insert the board nuts into the wall.

11. Set the washbasin cabinet onto the brackets. Be sure thecabinet adjusted level and the back board of cabinetappressed to the wall by adjusting the screws of wall clips.

12. Apply a washer to the screw before tighten it. Make surethe washbasin cabinet has been fixed firmly on the wall.

Caution!

Note:

Avoid the cables and pipes inner set whendrilling in the wall.

Different types of bolts are required for differentdecoration boards. Please apply suitable bolts and board nuts.

8.

9.

10.

11.

12.

Fig.77

B.Install Cabinet Board

Vanity Top

Attention: Handle with care when install the countertop.

Avoid scrubbing with hard dejects.

1. Apply some sealant to the top of sideboard of washbasin

cabinet, and position the integral cabinet washbasin in the

cabinet.

B.

1.

-6-1082405-T01-C

-7-

1. (P )

/

Connect Drainage

1. Inwall drainage (P-Trap)

Please install the drain assembly and faucet as shown.

Please set the water supply and drainage position

according to the suppliers instructions. You can adjust the

height of shelf to fit the drain assembly.

Faucet

Supply Lines

Shut-off Valve

Drain Assembly

Back BoardAdjustable Shelf

Fig.88

2. S2. Floor drainage (S-Trap)

Please install the drain assembly and faucet as shown.

Please set the water supply and drainage position

according to the suppliers instructions. You can adjust the

height of shelf to fit the drain assembly.

Faucet

Supply Lines

Shut-off Valve

Drain Assembly

Back BoardAdjustable Shelf

Ripple Pipe

Outlet

Fig.99

1082405-T01-C

-8-

3. S

Faucet

Supply Lines

Shut-off Valve

Back BoardAdjustable Shelf

Outlet

Fig.1010

3. Straight Floor Drainage (S-Trap)

If you can,t connect the drain assembly as mentioned

above, you may follow the method shown in the illustration

below.

: This method will cause the unretrievable distroy to the

cabinet, KOHLER company won,t take responsibility for such

problems.

NOTE

�

�

�

80mm

PVC

1

2

3

Fig.1111

�

�

�

Drill a hole which diameter no more than 80mm right above

the drain hole on the floor. And keep the edge smooth.

Apply proper sealant to the hole edge.

Cut proper length (the perimeter of the hole) of PVC

adhensive tape and curve it to joint with the hole edge.

1082405-T01-C

-9-

C. Finish the Installation

1. Install the cabinet door to the cabinet.

2. Adjust the hinge screw to flat the door.

C.

1.

2.

1 2

Fig.1212

1.

2.

3.

4.

5.

6.

USER MAINTENANCEUSER MAINTENANCE

Warn! Risk of product damage.

1.

2.

3.

4.

5.

6. Please do not sit, lean or step on the basin cabinet.

Many cleansers contain abrasive and chemical substancewhich is not suitable for cleaning stainless steel, enamel,plating or plastic products. You may use mild cleansers orsoaps to clean the surfaces. Wipe any splashes of cleanersolutions from the surface with clean soft cloth.

Maintain ventilation in the bathroom, and separate the dryarea from the damp one if conditions permit. Try to openthe door and windows of the bathroom and maintain goodventilation.

Kohler bathroom cabinet are dealt with strict proceduresfor damp-proof, whose good damp-proof function ensuresgood performance even in bathroom of huge humidity. Yetdo not splash and pour water directly on the bathroomcabinet. Make sure that the bathroom is not over dampand wipe any splashes from surfaces immediately.

Maintenance of door board: Clean and wipe door boardregularly, and wipe the condensation vapor with dry andsoft cloth.

Ensure that electrical connections for appliances such ashead lamp is insulated wipe mirror surface with chamoisregularly to guarantee the persistent excellent performance.

1082405-T01-C