Embed Size (px)
Citation preview
PROTON TECHNOLOGY IS A KNOWLEDGE-BASED BUSINESS
FOCUSED ON SURFACE TECHNOLOGY. Within the three business areas – Surface Testing, Surface Engineering and Surface Academy – we are providing
services such as materials analyses, verifi cation of surfaces, for example corrosion properties as well as consulting and training. Proton Technology is one of Europe’s
largest privately owned independent corrosion- and surface analysis laboratory.
ACCREDITED AND APPROVED. Proton Technology has a well-equipped lab, third-party accredited by SWEDAC, ISO/IEC 17025 for testing and verifi cation of
surfaces and coatings with over 50 test methods. We are also approved by Volvo AB, Scania, Ford, IKEA and Husqvarna, and have customers all over the world.
SERVICE WITHIN 24 HOURS. Proton Technology deliver 2000 test reports annu-ally, we apply a 100% confi dentiality. We start the test procedure within 24 hours
after recieving the material and deliver the test report directly after completed test.
SHIPPING AND VISITING ADDRESSProton Technology AB | Sjöåkravägen 28 | SE-564 31 Bankeryd, Sweden
CONTACTPhone +46 (0) 36 37 38 50 | [email protected] | www.protontechnology.se
Ackred. nr. 1975Provning
ISO/IEC 17025
Cyclic Corrosion Tests
• VAG PV1210
• nVDA 233-102
• ACT, Volvo 423-0014 & Scania STD4319
• ACT2, Volvo VCC 1027,1449 & Scania STD4445, Ford L-467
• VDA 621-415
• VDA DIN EN ISO 11997-1 Cycle B
• DBL 7382
• MAN 3018
Constant Climate Tests
• NSS, ISO 9227 & ASTM B117
• AASS, ISO 9227
• ISO 6270-2
• MAN 183-3
• Classifi cation ISO 12944, paints and varnishes, corrosion protection of steel structures
Coating Integrity Tests
• Water Jet spraying
• Stone-chip resistance
• Cross-cut test
• Knife test
• Burnishing
• Bending
• Quenching
• Water immersion (by itself or prior to adhesion test)
• Freezing (prior to adhesion- or coating integrity test)
Other services
• Coating thickness measurements by e.g. magnetic induction method, eddy current testing, coating drill, x-ray & microscopy
• Failure mode analysis
• Materials and surface characterisation
• SEM/EDS chemical analysis / composition
• Defect analysis, microstructure analysis / characterisation
• Cross section analysis of coatings and substrates
• Evaluation acc. to ISO 10289 (Rating, A-%, of appearance and rust protection RA,/RP), blistering, general corrosion, and propagation from scribe and more
• Training courses and education in Swedish and English language
• Technical support regarding corrosion and surface treatment, for example root cause analysis and product development
EXAMPLE OF SERVICES
Contact us for technical advice on standards, OEM-demands, requirement level and request for quotation.
Joakim Ekström, Technical Sales Manager
E-mail: [email protected] Phone +46 (0)36373853
Stefan Gustafsson Ledell, CEO
E-mail: [email protected] Phone +46 (0)36373851
SHIPPING AND VISITING ADDRESSProton Technology AB | Sjöåkravägen 28 | SE-564 31 Bankeryd, Sweden
CONTACTPhone +46 (0) 36 37 38 50 | [email protected] | www.protontechnology.se
