Diagram A - Parts List

Seam Ripper Kit #PKSR1 Single Blade #PKSR2 Double Blade (large & small) Kit Features •StyleA-SingleBlade,smallripperwithclip. Reversesintohandleforsafety.•StyleB-DoubleBlade,small&largerippers•Oneendreversesintohandleforsafety.

Required Accessories •7mm,PenMandrel•8mmDrillBit#PKPARK-8MM•8mmBarrelTrimmer(usefrom#PKTRIMKIT)•2pc.BushingsSet#PKFILEBU•2partglue,epoxyorInsta-cure(cyanoacrylate).

PSI Woodworking ProductsPKSR1, PKSR2

Preparing the Blank•Prepareandcutablankof3/4”orlarger,tothelengthofthebrasstube(add1/16”fortrimming)•Drilla8mmholethroughthecenteroftheblank.•Spreadglueoverthetube,insertintoblankwithatwistingmotiontospreadtheglueevenlyinside.•Centerthetubeinsidetheblank.•Whenglueisdry.Trimtheendsoftheblankflushtothetube.

Small Seam Ripper Retaining Spring Clip

CapTube

3-1/8”

Single Blade - #PKSR1 - A

Large Seam Ripper Small Seam Ripper

Tube

3-1/8”

Retaining Spring Retaining Spring

Double Blade - #PKSR2 - B

Single Blade

Large & Small Blades

Larger Blade

Smaller Blade

Small Blade

Stored Position

Protective Ball

Protective Ball

A

B

Diagram B - Turning the Blank

PSI Woodworking ProductsPKSR1, PKSR2

© 2011 PSI Woodworking • Philadelphia, PA 19115 v08/11

HeadstockSpacer Bushings Spacer Bushings

End Bushing(Larger)

End Bushing(Smaller) Lock Nut

Live Center

Mandrel

Tube

Turning the Blank• Place the bushings and blank according to Diagram B.• Use the larger end busing on one end and smaller bushing on the other. • Turn the material into a handle profile. Sand and finish.

AssemblyFor Single style:• Place the clip over the extension of the cap. Press this assembly into the

upper end of the handle with smaller diameter. • Slide the seam ripper assembly in and out to assure a secure fit.• If the spring does not hold properly (i.e. the spring slides into the tube) Take

a que-tip and dip into thin CA glue insert the spring and allow the CA to dry. The spring should now operate properly

For Both Styles:• Squeeze the retaining spring to a small round circle (DO NOT CREASE)

and insert into opening at the ends, Push in, flush to the surface. (Dia. C)• Push the ripper assembly into the hole(s) - For double blade-insert the larger

blade at the end turned with the larger diameter.Insert the smaller blade at the end with the smaller diameter. When not in use, for safety purposes, reverse the ripper to store the blade(s) inside the handle.

ø.440 ø.370

Diagram D - Bushing #PKFILEBU

Diagram C