Upload
others
View
2
Download
0
Embed Size (px)
Citation preview
4 32 1
Reset
1 2 < >...
Off / OnO / l
DSL
> Nur auf Anweisung von Swisscom entfernen.> Ôter uniquement sur instructions de Swisscom.> Rimuovere solo su instruzione di Swisscom.> Only remove when instructed by Swisscom
30 min
Quick Install Guide Swisscom TV English
Help with installation and commissioning
Please refer to the attached installation instructions («Setup Swisscom TV») for a more detailed help with installation and commissioning. If you have any questions about how to operate Swisscom TV, please refer to the enclosed operating instructions «Operating Swisscom TV».
1. Connect the Swisscom TV box and modem using the Ethernet cable. The green DSL light on the modem must light up.
2. Connect the Swisscom TV box and the TV using the HDMI cable. Use the SCART cable to connect an older TV. Details on this can be found in the attached instructions «Setup Swisscom TV».
3. Connect the Swisscom TV box to the power outlet and switch it on using the switch on the back. The Swisscom TV box loads and installs the latest version of the Swisscom TV software during commissioning. This process takes 30 minutes. It is completed when the clock on the display shows the correct time. Please do not switch off the Swisscom TV box!
4. Switch on the television and select the correct AV channel by using your TV remote control.
5. You‘re all set. Your Swisscom TV is now ready to use together with your Swisscom TV remote control.
Swisscom TV boxModem
Ethernet cable
Swisscom TV box
HDMI cable
Back of the television
Swisscom TV box
Power cord
Swisscom TV remote control Please insert the supplied batteries.