2
Recommended bulb 1 x 9 Watt ES LED energy efficient classic clear bulb or 1 x 42W ES eco halogen classic bulb Bulb not included Specifications Max. power: 60W Voltage: 240V, 50Hz Weight: 5.2kg Please retain these instructions for future use John Lewis Partnership 171 Victoria Street London SW1E 5NN johnlewis.com Made in India User manual Tommy Floor lamp

Recommended bulb User manual 1 x 9 Watt ES LED energy

  • Upload
    others

  • View
    2

  • Download
    0

Embed Size (px)

Citation preview

Recommended bulb1 x 9 Watt ES LED energy efficient classic clear bulb or1 x 42W ES eco halogen classic bulbBulb not included

SpecificationsMax. power: 60WVoltage: 240V, 50HzWeight: 5.2kg

Please retain these instructions for future use

John Lewis Partnership171 Victoria StreetLondon SW1E 5NNjohnlewis.com

Made in India

User manualTommyFloor lamp

Thank you for purchasing this Tommy floor lamp . Please read the instructions carefully before use to ensure safe and satisfactory operation of this product.

Warnings!The bulb and surrounding parts can become extremely hot during use.When changing a bulb always switch off at the mains first and allow the bulb to cool down before handlingThe max power indicated in the ‘Specifications’ section must not be exceeded.Dispose of used bulb carefully. For indoor use only.

Assembly1. Remove all protective packaging (Carton 1 and 2)

IMPORTANT NOTICE Plastic/plastic bags can be dangerous. To avoid danger and suffocation keep away from babies and children.2. Place the lamp with the feet of the legs on a stable surface, ensure that the legs are evenly spaced to approx. 50-60cm apart at the feet.3. Adjust the legs individually approximately 5-10cm maximum at any one time. Loosen one wing bolt (A), slide each leg out in sequence and re-secure with the wing bolt.4. Repeat this process for all three legs until the desired height is reached ensuring that the wing bolts are secured hand tight. 5. The lampholder height can also be independently adjusted, loosen the thumb screw (B) and gently raise the lampholder to the desired height, tighten the thumb screw hand tight to secure before releasing the lampholder.6. Remove the shade ring (C), add the shade (supplied in carton 2) and secure with the shade ring

Care instructionsEnsure that the product has been switched off and allowed to cool, using a soft dry clothWipe clean lamp base only, do not wipe the bulb.Before moving or adjusting ensure the product is disconnected from the electricity supply.

Parts list

1 x tripod base assembly 1 x 18” shade 1 x shade ring (C)

A

B

C