Upload
garrett-ally
View
223
Download
2
Tags:
Embed Size (px)
Citation preview
Replacing the Maintenance Kit
HP Printers
OIT lab services
Parts of the Maintenance Kits
1. The Fuser
2. Feed/Pickup Rollers
3. The Transfer Roller
Exit
Accessing the Parts
Top CoverTransfer Roller
Paper TrayFeed/Pickup Rollers
Left DoorFuser
ExitResetting the page count
Removing the Fuser
• Open the left door• Remove the duplexer
by pushing down on the green tab and slide it out.
Exit
Removing the Fuser
• Release the fuser by turning the blue levers down.
• Don’t turn the gray levers downward.
• Use the finger tabs, lift the fuser up and slide it out of the printer.
Blue Lever Finger Tab
Exit
Replacing the Fuser
• Remove the orange packing spacers (one on each side) from the new fuser.
• Slide the new fuser firmly into place.
• Be sure it is pushed in the printer beyond the lip of its supporting frame and is completely seated.
Exit
Replacing the Fuser
• Rotate the blue levers up to lock the fuser in place.– Repeat step 8 if levers do not rotate.
• Reinstall the duplexer.• Push the duplexer into the printer until it
locks in place. You will hear a clicking sound.
• Close the left door.
Exit
Accessing the Feed Rollers
• The feed rollers are inside the paper tray area
• Open tray 2 and pull it out until it stops.
• Remove the tray by lifting up while pulling the tray away from the printer.
• Repeat above steps for tray 3.
Exit
Removing the Feed Rollers
• Pinch the protruding tab
• Slide the roller off the shaft
• Replacement is the reverse of installation.
• Slide the new rollers onto each shaft until they click into place.
Exit
The Transfer Roller
• Open the top cover and remove the toner cartridge
• The transfer roller is located under the toner
• Caution: To prevent damage to the roller DO NOT touch the black foam roller.
Exit
Remove the Transfer Roller
• Grasp the blue gear on the left and lift it up just enough to clear the retainer clip.
• Slide the transfer roller left to release the right end.
• Remove the transfer roller assembly.
Exit
Replace the Transfer Roller
• Place the right end of the new shaft into the hole on the right side.
• Slide the roller to the right until the blue gear on the left is in place.
• Snap the blue gear into place.
Exit
Lock the Roller Guide
• Press the metal and black plastic guide until it snaps into place.– Note: If the guide is not
snapped into place jams will occur.
• Replace toner cartridge and close top cover and close the top cover.
Exit
Resetting the Page Count
• Close up the printer and turn the power on.
• At this point, reset the page count and printer message.
• For more information on resetting the page count visit the LM page.
Exit