Embed Size (px)
Citation preview
Derek Reynolds
Radiation Safety Officer, Quality Control Inspector, and Industrial Radiographer
(620)212-0764 | [email protected] | 202 South Allen Ave. Chanute, KS 66720
Summary
I am certified to SNT-TC-1A as a Level II in the following inspection methods: Liquid Penetrant, Magnetic Particle,
Radiography, and certified Level I in Ultrasonic Testing. I have also been maintaining the Radiation Safety program at
Chanute Manufacturing Company for approximately six months. In addition to job experience I am a member of the
Radiation Response Volunteer Corps, a subsidiary of the Kansas Department of Health and Environment.
Credentials
Liquid Penetrant Level II - ASNT and PED
RAM Industrial Radiographer, State of Illinois
Magnetic Particle Level II - ASNT and PED
Ultrasonic Testing Level I
Radiation Safety Officer
10/31/12
Experience
Clerk, Subway, Chanute, Kansas 8/06-8/10
Welders Helper, Chanute Manufacturing Co., Chanute, Kansas 7/11-6/12
Quality Control Inspector II, Chanute Manufacturing Co., Chanute, Kansas
Quality Control Inspector I, Chanute Manufacturing Co., Chanute, Kansas
6/12-12/14
12/14-Present
Education
High School Diploma, Chanute High School, Chanute, Kansas 2004-2008
Community Service
Radiation Response Volunteer, Radiation Response Volunteer Corps, Kansas City,
Kansas
2015-Present
As a volunteer in this program I am on a list of first responders to any radiological
emergency in, or near, Kansas. Duties involved with this position include: population
monitoring, area quarantine, decontamination of internal and external radioactive
material, and dispensation of information relating to short-term and long-term biological
effects of radiation exposure.
2
Supplementary Information
In addition to the certifications listed above I have extensive experience with the
following devices:
Micrometers: Both digital and dial; inside diameter and outside diameter of multiple
different configurations
Hardness Testers: Hammer Impact type Brinell, Clark CPT series Rockwell, and MIC10 UCI
Surface Comparator Gauge
G.A.L. Fillet Weld Gauges, Undercut Gauge, and Offset Gauge
Furthermore, I am comfortable in all stages of the manufacturing process. I have
experience with receiving inspection of machined parts, forgings, castings, and raw
material. I have invested time in material preparation and am familiar with punching,
shearing, breaking, and burning plate, bar, beams, cylinders, and cones. I have also had
abundant experience with tube bending inspection; calculating flow reduction, ovality,
wall thinning, and flatness.
I have also had ample time with fabrication inspection of both structural and pressure-
retaining welding to ASME Section I and VIII and AWS D1.1 and the testing that follows
with each code, including, but not limited to, hydrostatic pressure testing, helium testing,
pneumatic pressure testing, and recording the results of each.
