IMPORTANT!!

SPRINGS PER MODEL

(includes 2 extra springs)

PARTS LIST ALL MODELS4 - Legs4 - Frame Bars1 - Jumping Mat1 - Safety Pad1 - Safety Plaque w/ 2 Ties1 - Instruction Manual1 - Backyard Trampolining Book1 - Warranty Card

14' Super Bounce - 100 Springs16' Mega Bounce - 108 SpringsXL Big Air - 124 Springs

Set-up Instructions - PLEASE READ CAREFULLY BEFORE SET UP!NOTE: Before you begin, remove the shrink wrap from the end of each “round” frame bar. There is a small insert that is used to protect the bar during shipping. Remove this insert and discard.

1 2

Lay 4 frame bars in a complete circle on a level surface with the spring slots facing up. Place the 4 leg bars inside the circle with the leg ends near the leg insert sleeves on the frame bars. Note: Make sure there is one frame bar joint centered to each leg.

Lift 1 frame bar and slide a leg end into the leg insert sleeve on the frame bar. Repeat step for all 4 legs. Join the frame bars together to close the circle.

Place the trampoline jumping mat on the ground, inside the frame. Take one spring and hook any one triangle on the jumping mat. Hook the opposite end of the spring into the spring slot on the frame bar.

When pulling the spring, grab the spring at the end going into the hole in the frame. As shown above, avoid holding the spring in the red area as this will damage the spring.

3

ROUND TRAMPOLINESET-UP INSTRUCTIONSROUND TRAMPOLINESET-UP INSTRUCTIONSROUND TRAMPOLINESET-UP INSTRUCTIONSROUND TRAMPOLINESET-UP INSTRUCTIONS

SupeFun_instructions_8.5x11_FINAL.pdf 1 9/4/15 5:57 PM

ROUND TRAMPOLINESET-UP INSTRUCTIONSROUND TRAMPOLINESET-UP INSTRUCTIONS

Working around the trampoline, attach a spring on every tenth triangle and stretch the spring to the corresponding spring slot on the frame bar.

Add a second spring next to springs that where attached on Step 4. Repeat this process until all the springs are attached.

Lay out the safety pad on top of the springs. To fasten the safety pad, align spring loop (stitched to underside of pads) with spring. Unhook spring and pass it through the loop, then re-hook spring. Remember to hold spring in the correct position when pulling. Complete by fastening the velcro around the bar (velcro stitched to underside of pads).

WARNING: At no time is the trampoline to be used without safety pad

Attach the Safety Plaque with the plastic ties that were included. MUST BE VERY VISIBLE.

Should you need to disassemble your trampoline, simply repeat the set-up instructions in reverse order.

ENJOY YOUR SUPER-FUN TRAMPOLINE!www.trampoline.com For assistance or general inquiries call us at

1-800-663-2261

4

6

5

NOTE: 16' RD Mega Bounce & XL Big Air Trampolines have extra springs holes after you have completed every tenth spring. Simply continue around the trampoline hooking up one spring at a time. When you get to the end just hook up the remaining spring.

SupeFun_instructions_8.5x11_FINAL.pdf 2 9/4/15 5:57 PM