Upload
owen-simwanda
View
260
Download
57
Embed Size (px)
DESCRIPTION
RTWP Problem Troubleshooting Guidelines
Citation preview
document.xls 文档密级
04/17/2023 华为机密,未经许可不得扩散 第1页,共2页
Check List
SN Check Items Check Method
OMC Information Collection
1 Uplink RF sensitivity
2 Uplink Attenuation Value
3
4 check the RTWP counter or realtime RTWP monitor
5
6 analyze the interference feature
7 LMT uplink frequecny scannig do the scanning in NodeB LMT (need block the sector)
8 Check the intermodulation
Site visit and information collection
10 Visit the site
11
12
MML command: DSP RFDESPARAM / DSP DESENS
MML command: LST RXATTEN
Check the TMA gain(if TMA used)
MM command: LST TMAGAIN
whether nearby sites also have the same high RTWP feature
Describe the RTWP feature (like it is always high or some times high ). What is the RTWP range
MML command: STR RTWPRTTST (NodeB LMT)real time RTWP monitor (both primary and secondary RTWP)
compare the traffic load with the RTWP. Check whether high traffic or interferece cause the high RTWP.
MML command: SET TXSWswitch off the downlink tansmit power and monitor whether interference disapper or not
Whether 3G system shared antenna with 2G or not? Whether TMA used or not? Whether repeater is located nearby?
whether primary and secondary RTWP are both have high
swap the primary feeder with the secondary feeder to check whether high RTWP swap or not.
differentiate internal or external interference
Disconnect the jumper from the cabinet and then monitor the RTWP.
document.xls 文档密级
04/17/2023 华为机密,未经许可不得扩散 第2页,共2页
Check List
Check Result Remark
OMC Information Collection
Site visit and information collection