Air Repair, LLC specializes in air compressor repair, sales and service for oil injected rotary screw air compressors, oil free rotary screw air compressors, piston air compressors, refrigerant dryers, desiccant dryers, absorption dryers, and nitrogen generators in West Virginia, Maryland, Ohio and Pennsylvania. We are a distributor for Boge Air Compressors, FS Curtis Air Compressors and Rollair Air Compressors. Air Repair, LLC is an authorized dealer in specialized aluminum air piping from PREVOST Air Piping. Air Repair, LLC is a warranty service station for the following air compressor and air tool and manufacturers: STANLEY BLACK & DECKER, PORTER CABLE, and DeVILLBLISS. Air Repair, LLC offers complete service and repair for the following air compressor manufacturers: BOGE AIR COMPRESSORS, FS-CURTIS AIR COMPRESSORS, ROLAIR SYSTEMS AIR COMPRESSORS, SULLAIR AIR COMPRESSORS, QUINCY AIR COMPRESSORS, INGERSOLL RAND AIR COMPRESSORS, KAESER AIR COMPRESSORS, CHAMPION AIR COMPRESSORS, ATLAS COPCO AIR COMPRESSORS, GARDNER DENVER AIR COMPRESSORS, and CAMPBELL HAUSFELD AIR COMPRESSORS.
Citation preview
COMPRESSOR DATA SHEET Rotary Compressor: Fixed Speed MODEL DATA
- FOR COMPRESSED AIR1 Manufacturer: Model Number: 2X X
Boge Kompressoren S 50-2 Water-cooled Oil-free Date: Type: # of
Stages: 224.22b c
7/15/2011 Screw Single acfma,e b c
Air-cooled Oil-injecteda, e
Rated Capacity at Full Load Operating 3* 4 5 6 7 8 9 10* 11
Pressure
Full Load Operating Pressure
125 135 50 93.5 2.4 74e
psig
Maximum Full Flow Operating Pressure Drive MotorNominal Rating
Drive Motor Nominal Efficiency
psig hp
percent hp percent kWe
Fan Motor Nominal Rating (if applicable) Fan Motor Nominal
Efficiency Total Package Input Power at Zero Flow
9
Total Package Input Power at Rated Capacity d and Full Load
Operating Pressure Specific Package Input Power at Rated Capacity
and Full Load Operating Pressuree
kW 50
d
12*
kW/100 cfm 19.39
e
*For models that are tested in the CAGI Performance Verification
Program, these items are verified by the third party administrator.
www.cagi.org Consult CAGI websitefor a list of participants in the
third party verification program:NOTES: a. Measured at the
discharge terminal point of the compressor package in accordance
with ISO 1217, Annex C; ACFM is actual cubic feet per minute at
inlet conditions. b. The operating pressure at which the Capacity
(Item 3) and Electrical Consumption (Item 11) were measured for
this data sheet. c. Maximum pressure attainable at full flow,
usually the unload pressure setting for load/no load control or the
maximum pressure attainable before capacity control begins. May
require additional power. d. Total package input power at other
than reported operating points will vary with control strategy. e.
Tolerance is specified in ISO 1217, Annex C, as shown in table
below: Volume Flow Rate at specified conditionsm3 / min Below 0.5
0.5 to 1.5 1.5 to 15 ft3 / min Below 15 15 to 50 50 to 500 Above
500
Volume Flow Rate% +/- 7 +/- 6 +/- 5 +/- 4
Specific Energy Consumption% +/- 8 +/- 7 +/- 6 +/- 5
No Load / Zero Flow Power
+/- 10%
ROT 0305/11 R7
Above 15
This form was developed by the Compressed Air and Gas Institute
for the use of its members. CAGI has not independently verified the
reported data.
