1

ApplicationThese instructions are for recovering programming from a diagnostic tool using the Device Recovery application included with ScanBay.

These instructions apply to ALL Non-Windows® based Snap-on diagnostic tools with a USB connection (e.g. MODIS™, SOLUS™, ETHOS®, and TRITON-D8® diagnostic tool families).

Note: As this instruction sheet is intended for multiple markets, these instructions may apply to other diagnostic tools not listed in the example above. All images and illustrations used in this document are intended as examples, and are for reference only.

Before You BeginBefore using the Device Recovery application read these IMPORTANT notes.

• Using this Device Recovery application will remove ALL the saved data files from the diagnostic tool. Before using this application, copy all the files needed (saved customer data files) to your PC, separate storage media, or use ShopStream Connect.

• To avoid damage, DO NOT remove or disconnect the diagnostic tool from your PC during the recovery process. It is highly recommended to power the diagnostic tool with the AC power supply during this procedure to avoid accidental power loss.

Using the Device Recovery ApplicationProcedure:

1. Open the Device Recovery application from the desktop icon (Figure-1).

Figure 1 Desktop Icon

2. Enter your Chrome Dealer ID when prompted, including the “D” or “d” (not case-sensitive) (Figure-2).

3. Select Next to continue (Figure-2).

Figure 2 Login

Note: If the diagnostic tool is already connected; disconnect and then reconnect it. Only one diagnostic tool should be connected to the PC at a time.

4. Connect the USB cable to the mini USB jack on top of the diagnostic tool and to your PC.

5. From the Home screen, select Tools > Connect-to-PC (Figure-3).

Figure 3

6. Follow the screen prompts to complete the Connect-to-PC process (Figure-4).

Figure 4

DeviceRecovery

ScanBay™ - Device Recovery Software Instructions

EAZ0030B59E Rev. B 21-H-19© 2019 Snap-on Incorporated. All rights reserved.

2

ScanBay™ - Device Recovery Software Instructions

The Device Recovery application scans to detect the diagnostic tool (Figure-5).

Figure 5 diagnostic tool detection message

IMPORTANT: DO NOT remove or disconnect the diagnostic tool from the PC during the recovery process.

The Device Recovery application scans the media, then displays the results. Only media that is identified as a Snap-on diagnostic tool is detected(Figure-6).

7. Verify the correct diagnostic tool is recognized, then select Next to continue (Figure-6).

Figure 6 Media identification message

A “Ready to program diagnostic tool” message displays showing the software version number (Figure-7).

8. Verify the software version is correct, then select Next to begin the recovery process (Figure-7).

Figure 7 Ready to program message

A progress indicator screen displays during programming. After programming is finished a Completed” message displays (Figure-8).

9. Select Next (Figure-8).

Figure-8 Programming complete message

10. When the “Completing the wizard” screen displays, select Finish to finalize the operation (Figure-9).

Figure-9 Programming complete message

11. Disconnect the diagnostic tool.

12. Restart the diagnostic tool to verify it operates.

SOLUS Edge

409PHA50098C

SOLUS Edge XX.X