Upload
others
View
1
Download
0
Embed Size (px)
Citation preview
Your Shapeoko shipped with an updated and improved z-plate. The new z-plate is more rigid and provides additional Z travel for your machine.
Use the following diagram to assemble your z-plate correctly. Note the pulley orientation below
The belt should interlock with itself as it routes through the 15mm standoffs
Note: When looking from the front view, the fixed pulley should be on the left side of the assembly. If you install the z-plate opposite of what is shown in the photo, your z-axis polarity will be reversed.
Please contact [email protected] if you have any questions or problems installing the new z-plate.
(front view)
(rear view)
Shapeoko Z-Plate Assembly
06/02/2016 Revision 1
mailto:[email protected]