Upload
others
View
4
Download
0
Embed Size (px)
Citation preview
Case Study
• A bespoke structural elastomeric bearing for the structural isolation of buildings and other structures
• Series of elastomer pads laminated to formwork
Stravibase SEB
SMART Byty apartment buildings are situated very
close to Nové Butovice metro station and just a
few metres from the tunnels in Prague. The roughly
300 apartments are equipped with energy-efficient
intelligent technologies.
OVERVIEW
Smart Byty Prague, CZ
Property Owner
Trigema s.r.o.
Architect
Trigema s.r.o.
Structural Engineer
STA-CON s.r.o.
Main Contractor
SKANSKA a.s.
Acoustic Consultant
Modus-Fz (Fülöp Augusztinovicz)
492 000 KN
Acoustic Design Load
REUTENBEEK 9-11, 3090 OVERIJSE, BELGIUMT +32 2 687 79 07 / F +32 2 687 35 52 [email protected] / WWW.CDM-STRAVITEC.COM
SOLUTION
The tunnels next to the buildings posed a challenge
for the designers to meet the strict noise level criteria.
The acoustic study concluded that in order to remain
below the limit in the apartments, the two buildings
closer to the tunnel should be constructed on a 11 Hz
system, while the other two buildings further from the
tunnel require a system with a resonance frequency of
15 Hz.
Based on the vibration isolation study, CDM Stravitec
offered the Stravibase SEB system for the project, with
50 mm and 30 mm high bearings. The vibration cut was
located at Level -2, on top of the walls and columns,
just below the floor slab of Level -1.
After the installation, the building received all the
permits and the residents are enjoying, since their
move, the quick access to the metro without being
disturbed by it.