SmartStruxure™ Lite Solution Course SmartStruxure Lite Introduction HOW ALL FITS TOGETHER PPT ver. 1.1.0.0

SmartStruxure™ Lite Solution

Course SmartStruxure Lite IntroductionHOW ALL FITS TOGETHER

PPT ver. 1.1.0.0

Schneider Electric 2- SmartStruxure™ Lite solution Training

Monitor

BACnet points collected by the monitor

http

Cost effective solution for small-to-medium buildings

StruxureWare Building Expert (in web browser)Allows to configure and monitor your deployment.

IP/Ethernet network design

Stand-alone deployment, everything goes through the monitor

Ethernet LAN

Passive nodes

LAN

(A monitor is needed if more then 1 MPM in the network and if a network functionality is required)


Ethernet LAN BACnet points collected by the BMS directly

BACnet IP /BACnet Ethernet

Schneider Electric or third-party BACnet Building Management System (BMS)

Passive nodes

LAN

IP/Ethernet network design (cont’d)

Integration to BACnet systemNo need for a monitor if all nodes are connected through IP


●Guidelines – network traffic only● CANBus, Ethernet, ZigBee: ● Ratio of 24 passive nodes to 1 monitor node

Monitor

Ethernet LANor

CANbusor

ZigBee

Group A

Monitor Monitor

Group B Group C

BMS

General network design

LAN

Up to 24 nodes per group


Ethernet

LAN

Monitor

Network discoveryStruxureWare Building Expert(in web browser)

Monitor send a heartbeat request

By the network discover y command and every 10 minutes


Passive nodes

Remote database download

End-devices

LAN

StruxureWare Building Expert(in web browser)

Ethernet

Network discovery (continued)

Monitor

The Monitor plays a significant role both for monitoring and for networking


Property Casts sent on change of value (COV) 30 seconds by default.

22.8 °C23.0 °C

Normal operation – COV based

Passive nodes

LAN

StruxureWare Building Expert(in web browser)

Ethernet

Monitor


●120 Ohms resistors must be placed at both termination points of the CANbus chain link.

●CANbus transfer rate is proportional to total chain-link length.

● 125 Kbps: Up to 500 m● 250 kbps: Up to 250 m (default setting)● 500 kbps: Up to 100 m● Must be the same speed configuration for all

MPMs

BMS

Monitor passive nodes

CANbus network design

LAN


● ZigBee coordinator is a device that sets up the network, is aware of all the nodes within its network. Every ZigBee network must contain a network coordinator.

● ZigBee router can act as an intermediate router, passing on data from other devices.

MonitorRouter nodes

End-devices

Coordinator

ZigBee concepts

BMS

LAN


●Route redundancy●Ideally no more than 5 wireless hops●Example respecting guidelines

Site Monitor

Router / Passive nodes

Coordinator

BMS

LAN

Building Expert

ZigBee network design – best practices


●No Route redundancy●Example not respecting guidelines

Monitor

Passive nodes

Coordinator

BMS

LAN

Building Expert

BAD wireless network design

Passive nodes

& Routers& Routers


●Possible if the Monitor is the originating point of each technology segment.

BMS

Monitor

Passive nodes

Web browser

Coordinator

ZigBee

Ethernet

CANBus

Passive nodes

Passive nodes

LAN

Using multiple network technology

Caution!This is a theoretical and principal schematic.

Other

Get started

Application package



Uses cases

Schools

Hotels


Water based heating systems● Perimeter heating with radiators● Perimeter heating with fan coils

School schedules● Can’t disturb classes● Can’t afford overtime pay

Out-buildings

Hazards in the walls● Dust or asbestos fears

Tight budget● Fixed costs of front-end, servers

and gateways limiting the ROI?

Proven solution● Smart wireless actuator● Wireless room and terminal controllers

Wireless retrofit during school days● Limit wiring to a minimum● Limit invasiveness and disturbance

Bring them in wirelessly with ZigBee

Avoid renovation, repair & repaint work● Keep parents and administrators happy

StruxureWare™ Building Expert● No license fee! Low fixed costs!● Scalable to StruxureWare™ Building

Operation, BACnet, EcoStruxure Web Services, oBIX

School NeedsSmartStruxure™ Lite answers


Perimeter heating school retrofit jobProblem● Single loop perimeter heating● Comfort & energy cost issues

Objectives● Add zone & remote control● With a short payback

Solution● Managers

● Network throughout the building● Control actuators● Receive data from sensors● Host Building Expert over the LAN

● Smart wireless actuators

● EnOcean T° sensors

● Management via Building Expert

Boiler

LAN


Unit ventilator/fan coil school retrofit jobWireless manager(one unit can manage many zones)

If there are no old stats or existing wiring isn’t usable, place SEC-TE inside unit

Swap old stat with SE7000

Network to other zones Light relay

with dimming

Light sensor and light switch

LAN

Building Expert

Unit ventilator or fan coil


Out-buildings & school trailersSchools run out of space and use out-buildings to fill gap● Integrating these buildings into an automation system is difficult & costly● SmartStruxure™ Lite can integrate them easily and at a low cost● Manage multiple buildings from StruxureWare Building Expert or use larger

systems

Up to 300 m line of sight

StruxureWare™Building Expert

EcoStruxureWebService

internet

internet


Use case: simple & complete automationObjectives: happy guests & bottom line● Control heating and cooling costs

● Get your guests in the comfort zone

● Remote management for more efficiency

Solution● SE7000 to control HVAC in each room

● Embedded PIR motion sensor (optional) sets temperature for occupied/unoccupied mode

● Guests can adjust setpoints for comfort

● Networking and integration performed by MPM devices each handling several zones

● Management can set high and low limits according to schedules

● Management can put rooms into vacant mode for maximum energy savings

Room 205

Room 207

Room 209

Room 211

Room 204

Room 206

Room 208

Room 210

MPM-GW

SE7000

FC, HP


Room 205

Use case: simple & complete automation

Solution (cont’d)● Management via StruxureWare™

Building Expert

● Can import hotel floorplans and define custom zones with color codes for user-friendly visualizations

Scale over time with wireless● Easily add points with EnOcean and

ZigBee

● Lighting control

● Additional sensors

● Other applications

● Can integrate wireless keycard reader to set occupied/unoccupied mode

Light relay

Keycard reader


Use case: comfort, efficency & branding

Swap old stat with SE8000

PIR motion sensor included

my Hotel

Create loyalty with your brandCustomizable cover, color, language and screensaver

Direct integration to BACnet

Fan coil, heat pump or other system

Or integration via MPM devices

StruxureWare Building Expert for small hotels and motels. Integrate to other systems for larger buildings.

Use relay pack for high voltage fan coils

LAN

300 ft

200 ft

● Small retail outlet● 4 zones - HVAC● Monitoring only

Example scenario 1

300 ft

200 ft

● A few SE7000● One MPM connected to the LAN● Management with StruxureWare

Building Expert

Example scenario 1

LAN

Example scenario 2

300 ft

200 ft

● Small retail outlet● 5 zones - Lighting● Monitoring and Override

Example scenario 2

200 ft

● Two MPM-GW communicating via ZigBee● Control of multiple EnOcean switches and relays● Management with Building Expert

300 ft

LAN

ZigBee RouterPassive

ZigBee CoordinatorSite MonitorConnected to LAN

Example scenario 3

300 ft

200 ft

● Small retail outlet● 5 zones - Lighting● Monitoring and Override● Energy Metering

Example scenario 3● Add MPM-UN with Modbus

to connect power meter

LAN



ZigBee CoordinatorSite MonitorConnected to LAN

Modbus power meter


Application:

Hotel room,Dorm room,Old age unitorHospital room

FancoilUnit

Room 101

SmartStruxure LiteMonitoring & Control Solution

Window Sensor

ThermostatDoor

Sensor

Floor / HotelController

Web-pages for simple monitoring

& control

SmartStruxure SolutionFull Building Management System

AutomationServer

SmartStruxureEntreprise Server

or

SmartStruxureBuilding Operation


VAV applications

VAV managers(MPM-VA)

Terminal controllers(if direct control of RTUs is needed)

Building Expert

MPM device

If requiredAdditional wired and wireless sensors for

T°, H%, motion, CO2, etc.

Each VAV manager has:• Embedded pressure sensor• 6 inputs and 6 outputs• EnOcean wireless I/O• Support for ZigBee peripherals

RTU or other HVAC equipment

Zoning

HVACAggregation & management

VAV boxes

Use VAV managers● Each unit has:

● Pressure sensor● Actuator (optional)

● Wireless networking ● Makes installation

faster and easier

●Building Expert● Has a PID loop

object to help manage VAVs.

● Programming is stored locally on each VAV manager for redundancy.


Metering and Sub-metering

For electrical, gas & water metering● Multi-purpose managers can integrate

Modbus, EnOcean and ZigBee metering and pulse-counting devices

● Building Expert has objects to facilitate the integration of select Schneider Electric and Veris products. Currently, these products are:

● ION6200● PM750● Veris E5 series● Veris H803 series● iEM3250/5● PM3250/5

● Data can be:● Viewed in Building Expert● Integrated into larger iBMS● Exported over FTP

Building Expert

MPM-UN

Metering

Schneider Electric and Veris meters with objects in Building Expert to facilitate their integration.

Other Modbus meters.

You can network to reach metering points separated by long distances

Pulse counting and smart plugs

Terminal controllers can be used for fast pulse counting

MPM-UN can integrate various devices using Modbus, EnOcean and ZigBee protocols


Basic and advanced lightingOffice single load, common areas and outdoor lighting

Wired and/or wireless lighting control● For wired and wireless

control, use the MPM-UN● For wireless control only,

use the MPM-GW

Building Expert and EnOcean● Objects to facilitate the

integration of light switches and relays already exist.

● New objects are coming up for the following sensors: motion, light (lux), door contact and window contact

Building Expert

MPM-UN

Basic lighting Daylight harvesting

Connection to Modbus lighting

panel or wired contacts

Relay

Switch

Occupancy sensor

Light sensor

Dimmingrelay

Relays for motorized

blinds & smart windows

MPM-GW


●StruxureWare Building Expert is a complete building automation IP

interface available from any internet connection.

●The Web server is active on every Manager (MPM).

●No license, no software to install

●Used to monitor and commission your network

●Supported browser: Firefox ESR

●From version 2.7 are the most

common browsers supported

●Local port : 80

StruxureWare™ Building Expert


Resources for you

●Product Support Services (PPS) – After an approved certification test●The Schneider Electric Exchange Download Center

● (https://buildingsdownloads.schneider-electric.com)

●Documentation.SmartStruxureLite.com● Still valid but the above download center is the recommended solution

https://buildingsdownloads.schneider-electric.com/

End

Documents

SmartStruxure™ Lite Solution Course SmartStruxure Lite Introduction HOW ALL FITS TOGETHER PPT ver. 1.1.0.0