Sony NWZ-E473 Battery Replacement - Amazon …...手順 6 — Battery Peel back layer of tape. Remove processor located below tape and down from the battery using tweezers and spudger

Sony NWZ-E473 Battery ReplacementThis is a guide showing you how to replace the battery in a Sony NWZ-E473.

作成者: Matthew Hintz

Sony NWZ-E473 Battery Replacement 下書き： 2020-02-19ガイド ID: 36362 -

ã “ã ®æ–‡æ›¸ã ¯2020-02-28 09:31:07 PM (MST)ã «ä½œæˆ ã •ã‚Œã ¾ã —ã Ÿã€‚

© iFixit — CC BY-NC-SA jp.iFixit.com ãƒšãƒ¼ã‚¸7ã ®1

はじめにはじめに

To complete this Sony NWZ-E473 guide, a soldering iron will be needed. You may want to havesomeone with soldering iron experience complete that step or watch some basic videos on how touse a soldering iron.

ツールツール:Phillips #00 Screwdriver (1)iFixit Opening Tools (1)Tweezers (1)Soldering Iron (1)




手順手順 1 — Back Panel

Use a Phillips #00 screwdriver tounscrew the two 5 mm screwslocated on the bottom of the back ofthe device.

手順手順 2

Use a plastic opening tool to loosenthe bottom portion of device.




手順手順 3

Use a plastic opening tool to loosenthe top panel of the device.

手順手順 4

Use a Phillips #00 screwdriver toremove the two 3 mm screwslocated on the portion under the toppanel of the device.




手順手順 5

Remove the back plate from the device.

手順手順 6 — Battery

Peel back the layer of tape along with the processor, which is located just below the battery, usingthe tweezers and the spudger.




手順手順 7

Slide a prying tool underneath the top portion of the battery and lift it from the case.

手順手順 8

Remove the stickers from thebattery terminals, which are on theunderside of the battery.




To reassemble your device, follow these instructions in reverse order.

手順手順 9

Use a soldering iron to remove thewires from the red and the blackterminals.




Documents

Sony NWZ-E473 Battery Replacement - Amazon …...手順 6 — Battery Peel back layer of tape. Remove processor located below tape and down from the battery using tweezers and spudger