Upload
others
View
3
Download
0
Embed Size (px)
Citation preview
SUPPLIES
STEP 1Trim card stock to 6” x 8” to create cover. Using a pencil, mark the center on top and bottom at 4”.
STEP 3Trim 3 sheets of text weight paper to5 ¾” x 7 ¾”. Using a pencil, mark the center on top and bottom at of each page at 3 ⅞”.
STEP 4Use washi tape to a�x shorter spine die to center and die cut. Fold at score line and layer pages to create inside signature.
4”
STEP 2Use washi tape to a�x long spine die to center and die cut. Fold at score line and crease.
3 ⅞”
Bookbinding needle
Paper trimmer
Ruler
Pencil
Washi tape
Score tool
S4-1010 Paul Antonio for Spellbinders® Booklet Binding Set
PL-001 or PE-100 Platinum™Die Cut Machine
Cardstock for cover
3 sheets of text weight paper
2 ply waxed linen thread(3 lengths of the spine)
@PASCRIBE
Paul Antonio Scribe for Spellbinders® Booklet Binding Set Instructions
AStart from inside the book, with the middle hole. Leave a tail of thread inside.
STEP 5Using needle and thread bind booklet as shown.
BPush the needle into an end hole, from outside of the book to the inside.
CFrom inside, push the needle out through the third hole.
DComplete the stitch by pulling the needle back through the middle stitch, from outside of the book to the inside.
@PASCRIBE