Upload
dongoc
View
218
Download
1
Embed Size (px)
Citation preview
_________________________________________________________________________________________________________________ TSIB 15-03, rev A Page 1 of 1 November 6, 2015
TECHNICAL SERVICE INFORMATION BULLETIN
TSIB 15-03, rev A November 6, 2015
TO: All Operators
TITLE: ISE Vansco PLC Programming
APPLICABILITY: All ISE New Flyer Buses
This notice is to inform you of the programming requirement when replacing a Vansco VMM on the ISE system.
When a VMM1210 is replaced in the ISE system with a new low profile VMM1210, there is potential for
intermittent CAN communication issues to occur. This has been noticed on a small number of buses. Extensive
testing has been performed and the issue likely originates from having different application codes installed in each
VMM1210 on the network. Note that the ISE system only has two VMM1210 modules. As a precautionary
measure, it is recommended to install the latest application code into the system after the VMM1210 has been
installed.
Before continuing with the download, use the Query VMMs… function to
ensure you are able to communicate with two (2) Vansco VMM1210
modules.
The download can be performed by opening the Vansco VMM software,
click on Tools -> Download Application…
From there, browse for the latest application code and begin download.
Application code can be downloaded from here:
http://divapps.parker.com/divapps/iqan/VanscoVMMS.html
o Note: Use application code version 7.2.1.11 or newer.
After the application code has been updated, the VMM software will automatically download into the new VMM
module if it hasn’t already done so. If the system does not perform the download, you must use the Download
Logic… function to download the ISE VMM Software. Ensure you have this software before performing any
changes to prevent a system lockout.
Direct all inquiries regarding this bulletin to:
Ryan Bilan Technical Field Support Manager New Flyer Service Organization
(204) 224-6711