Embed Size (px)
Citation preview
1www.fernox.com
TF1 OMEGA FILTERDesigned for installation in small or restricted access areas, this high performance, easy to clean system filter uses Hydronic Particle Separation and magnetic filtration to remove contaminants from central heating system water.
Product Specifications
Weight
n High capacity and compact design
n Ideal for use in restricted spaces and access areas
n Easy to install – fits on horizontal and vertical pipework in both flow directions. The filter can operate at an angle of 45°
n Fast and easy to clean without dismantling the unit
n Unique action, removes magnetic and non-magnetic contaminants from system water
n Easy to fit slip socket with compression fitting and short pipe cut-out length
n Will not block or restrict flow
n Smart, tough, forged brass construction (no hidden porosity) with nickel plating
n Unique manifold with double radial seals and multiple orientation capability
n Powerful neodymium magnet assembly with threaded magnet cap
n As with all magnetic products, if you have an implanted cardiac device extra caution should be taken at all times when handling any magnetic filter
n Available as 22mm and 28mm products
n Maximum operating temperature: 100°C
n Maximum operating pressure: 10 bar
n Maximum flow rate: 50 L/min
n Magnetic characteristics: Powerful neodymium magnetic assembly
n Drain valve characteristics: Easy to install with multiple orientation capability
n Filter material: Tough, forged brass construction with nickel plating. Compatible with EN 12165-CW617N-M
TF1 Omega Filter 22mm 1615g (with magnet and drain valve)
TF1 Omega Filter 28mm 1695g (with magnet and drain valve)
V.003
TF1 Omega Filter 22mm TF1 Omega Filter 28mm
63m
m
63.5
mm
49m
m
49m
m
160m
m
160m
m209m
m
209m
m117mm 118mm 124mm 118mm
Cleaning Guide
3. Remove the magnet by unscrewing the magnet cap.
4. When the water runs clear close the drain valve, reinsert the magnet and restart the boiler.
2www.fernox.com
Ensure that the magnet sheath remains clean and dry.
1. Stop the boiler/system pump.
2. Open the drain valve.
V.003
Ø69
mm
Ø69
mm
3www.fernox.com
Dosing Guide Easy dosing of Fernox Expressproducts via a TF1 Filter with aslip socket connection.Note: If the filter containsmagnetite or sludge, flush itclean with water before dosing.Refer to the cleaning guideinstructions.Caution: Hot surface.
?
30 sec.
TF1
TF1 TF1 TF1 TF1TF1
TF1 TF1
TF1TF1TF1 TF1
30 sec.
TF1
==
ApplicationDesigned to be installed close to the wall, the filter can be easily fitted into either horizontal or vertical pipework in both flow directions.
Inhibitor usage guidelinesA TF1 Omega Filter will protect the boiler from the damaging effects of circulating corrosion debris, which has collected in the system as a result of a chemical reaction when water comes into contact with mixed metals used within a heating and cooling system. Note: to prevent further corrosion from taking place a quality inhibitor should be used in combination with the TF1 Omega Filter. In circumstances where demineralised or softened water is present a quality inhibitor must be used.
Packaging, Handling and StorageIndividually packaged with instructions included. No special storage requirements. Spare parts available from Fernox: Tel: +44 (0) 330 100 7750 Email: [email protected]
Product CodesTF1 Omega Filter 22mm – 62248 TF1 Omega Filter 28mm – 62251 TF1 Omega Filter Flushing Adapter – 62289
Pressure Loss Data
1.
5.
2.
6.
3.
7.
4.
V.003
20
30
40
5060
80
8
65
4
3
2
1
Pre
ssur
e d
rop
- ∆p
10
100
0.2
0.3
0.4
0.50.6
0.8
0.08
0.060.05
0.04
0.03
0.02
0.01
0.1
1kPabar
2
3
4
56
8
0.8
0.60.5
0.4
0.3
0.2
1
10
PSI15
22 28
Flow Rate - Q
0.1 0.2 0.3 0.4 0.6 0.8 21 3 (m3/h)4 6
0.2 0.3 0.4 0.6 0.8 21 3 (l/s)4 6 108 20
10 20 30 400.6 0.8 21 3 (GPMUS)4 6
10 20 30 4021 3 (l/min)4 6 50 80 100 200 300 400 500 800 1000
0.02 0.03 0.04 0.06 0.10.08
10 20 30 40 60
100 200 300600.40.3
