TP Project Power Train--ZXDU68 W301 DG Delay1

7/29/2019 TP Project Power Train--ZXDU68 W301 DG Delay1

1/12

Power Training for D.G. delay sta

Applied to ZXDU68 W301/T601 Ver. 5

Prepared B


2/12

Content

ATS relay control Generator Start

Serial Connect Rectifier D.G. control relay

How to find 2relay port?

Function verify at site with Manual Mode

D.G. Auto start & stop testing @Auto Mod

GEM active alarms o/p from SIU


3/12

ATS relay control Generator Start Princip

There is ATS rel

status is OPEN.

When CP OFF, t

relay is change t

Then AMF remo

Generator.

When CP is ON,

active, and relay

Then AMF remo

Generator.


4/12

Serial Connect Rectifier D.G. control relaAfter W301 D.G. cont

Open) serial connect w

D.G. start was controll

When CP OFF, ATS se

battery discharge, whe

start voltageDC Low

Low), then CSU relay

changed to CLOSE .

Then AMF remote star

When CP is ON, the se

circuit is OPEN, then A

the Generator.

When Generator charg

Capacity 100% achiev


5/12

How to find 2relay port?----CSU Relay Rectifier Relay from SIB board X17 PIN1&2


6/12

How to find 2relay port?----ATS RelayIf you dont know ATS control, D.G. maintenance guy can find it easy

You can find the relay at AMF side or ATS box side.


7/12

Function verify at site with Manual Mode1st change the Generator Mode to Manual in CSU Batt Para(password:0063)

2nd Switch OFF CP(@MCCB) before ATS, make sure ATS relay is act.

3rd find GEN Ctrl in CSU Ctrl menu, Turn On/Off GEN to verify the function of C

After Manual M

change back Ge

Auto, and test w

0063


8/12

D.G. Auto start&stop testing @Auto Mode

2nd change the DC Low Vol. & Batt. Low Volt as 53.0V in CSU Batt Para(password:0063)

1st MCCB switch OFF, ATS relay act.

3rd When DC voltage & Batt Volt


9/12

GEM active Alarm

GEM Active alarm:

Its port is SIU Output port 1(Comm1 and NO1), also need to configure BDischarge output relay as A1.

Below are the steps in Para Settings

Para Set > (Password0063)> Alarm Attri. > Batt Discharge > Relay > A1

(> Means Enter)

Take it from b/m slide port and patch it at DDF port 5(White/Grey). For t

power Off AC breaker and Site on batteries then GEM active alarm app


10/12

GEM active alarms o/p port in SIU.


11/12

Site on-line support:

First call: Abid Khan, 03134774307 TP Ran Power MangeNajeeb, 03458541071 TP Ran Power Manger @C1

Mansoor Malik, 03456190036 TP Ran Power Mang

Anjum Sohail, 03453198563 TP Ran Power Manag

Second Call: JunSan, 03145101341 Power proManager@PK


12/12

Documents

TP Project Power Train--ZXDU68 W301 DG Delay1