>>User name:root >>User password: UA5000(config)#vlan 4000 standard // Vlan for managment //IP address for IPMD

UA5000(config)#interface vlanif 4000 UA5000(config-if-vlanif4000)#ip address 10.1.16.81 24 { |sub }: Command: ip address 10.1.16.81 24 UA5000(config-if-vlanif4000)#quit UA5000(config)#port vlan 4000 r vlan { frameid/slotid|to }:0/2 { portlist }:0 Command: port vlan 4000 0/2 0 UA5000(config)#vlan 51 smart

//to make the port fo

// service vlan

UA5000(config)#vlan attrib 51 stacking UA5000(config)#multi-service-port vlan 51 board // add service port f or all board { frameid }:0 { num-list }:6-35 { autosense|rx-cttr|user-8021p|user-encap|user-vlan|vpi }:vpi { vpi }:8 { vci }:vci { vci }:35 { rx-cttr|user-8021p|user-encap|user-vlan }:rx-cttr { rx-index }:6 { tx-cttr }:tx-cttr { tx-index }:6 Command: multi-service-port vlan 51 board 0 6-35 vpi 0 vci 35 rx-cttr 6 tx-cttr UA5000(config)#stacking label vlan 51 { baselabel }:baselabel { baselabel }:2 // start from 2, but if one site use the same vlan, so this need to start from the other frame finish Command: stacking label vlan 51 baselabel 2 UA5000(config)#save { |configuration|data }: Command: save UA5000(config)#port vlan 51 { frameid/slotid|to }:0/2 { portlist }:0 Command: port vlan 51 0/2 0 // to make vlan lable

UA5000(config)#interface ipm { frameid/slotid }:0/2 Command: interface ipm 0/2 UA5000(config-if-ipm-0/2)#link-aggregation { port-list }:0-1 { mode }:ingress { |workmode }:workmode { lacp-static }:lacp-static Command: link-aggregation 0-1 ingress workmode lacp-static UA5000(config-if-ipm-0/2)#quit UA5000(config)#protect UA5000(config-protect)#protect-group { first|switch-over }:first { frameid/slotid/portid|frameid/slotid }:0/2/0 { second }:second { frameid/slotid/portid }:0/3/0 { atm|eth }:eth { workmode }:workmode { lacp|portstate|timedelay }:lacp { disable|enable }:enable Command: protect-group first 0/2/0 second 0/3/0 eth workmode lacp enable UA5000(config-protect)#quit UA5000(config)#save

for Native:-------------------------normally no need to do this part UA5000(config)#interface ipm 0/2 //inter to ipm active board UA5000(config-if-ipm-0/2)#native-vlan // add native vlan { all|portid }:0 { vlan }:vlan { vlanid }:1015 Command: native-vlan 0 vlan 1015

//Vlan ID