Upload
amelia-atkinson
View
216
Download
2
Embed Size (px)
Citation preview
0 500 1000 1500 2000 250060
80
100
120
140
160
180BP derived from Portapress
[mm
Hg]
sec
0 500 1000 1500 2000 25000.05
0.1
0.15
0.2
0.25PTT calculation with average
sec
sec
• Usually, the interval between the peak of the R-wave on the ECG and the onset of the corresponding pulse in the finger pad measured by PPG is defined as the PTT.• However, there is a considerable delay between the electrical cardiac activity (R-peak) and the mechanical ventricular ejection. This delay is referred to as the Pre-Ejection Period (PEP). The PEP is affected by pathologies, drugs and other factors, and therefore can cause impreciseness in the PTT measurement, and in the PTT-BP correlation.• Ballistocardiography (BCG) is the recording of the movements of the body caused by shifts in the center mass of blood in the arterial system and, to a lesser extent, of the heart, caused by cardiac contraction.
1529 1530 1531 1532 1533 1534 1535 1536 1537 1538 15399
9.2
9.4
9.6
9.8x 10
6 BP signal with max points identifying heartbeats
1529 1530 1531 1532 1533 1534 1535 1536 1537 1538 1539-1
-0.5
0
0.5
1x 10
5 Chest signal with minmax points
sec
1529 1530 1531 1532 1533 1534 1535 1536 1537 1538 1539-4
-2
0
2
4x 10
4 Pelvis signal with minmax points
sec
241.2 241.4 241.6 241.8 242 242.2 242.4 242.6 242.8 243
-4
-3
-2
-1
0
1
2
3
4
x 104
185 186 187 188 189 190 191 192 193 194 19550
100
150Portapress BP signal- not filtered
sec
BP
[m
mH
g]
185 186 187 188 189 190 191 192 193 194 1958.35
8.36
8.37
8.38
8.39
8.4x 10
6 Chest & Pelvis signals- not filtered
sec
1) Synchronized signals not filtered, received from the reference BP device Portapress (in the upper graph) and from EverOn sensors (in the lower graph) at rest. Chest signal in blue, Pelvic signal in green.
2) Proving that pelvic signal is comprised of: 1. signal generated in the heart and moved within the mattress to the pelvic sensor and most important 2. signal generated in the pelvic area of the body.
3) Final experiment
Real- time Detection of Blood Pressure changes
using contact free sensorsPresenting student: Efrat Herbst Instructed by: Zvika Shinar
To prove that signals are transmitted through the mattress and thus signal detected in each sensor is the superposition of the signal generated by the blood stream above the sensor with signal generated somewhere else and was Transmitted to the sensor through the mattress.Examining whether PTT can be measured using two EverOn sensors, placed under different locations of the body.
I. Median ratio between max/min peak to peak amplitude:
II. In preliminary calculations, PTT changes were found in the holding breath protocols: 55 [ms] relative to a 50 [mmHg] change in systolic BP and 70 [ms] relative to 60 [mmHg]:
Objectives
Introduction Methods Results
Discussion and ConclusionsI. Identifying the beat that arrives the pelvic area is critical. If we had
found that the signal received in the pelvic sensor is composed only by the chest signal transferred through the mattress, we had no point in continue this research. In our experiments we saw that signal generated by the pelvic area can be isolated and thus method is applicable.
II. As predicted, Change of PTT was found when BP changed. The relative is of 1.1 [ms] to 1[mmHg].
III. It seems that hand gripping for 5 minutes in order to change BP caused trembling of the hand, which makes it more difficult to find the heart beats and thus analyze the PTT.
IV. To the future, it is important to create a system that has the same clock sampler for all sensors, because of the importance of synchronized signals to the extent of a single heart beat.
Separated mattressesOne mattress
1st rest period1.25641.5629
2nd rest period1.44641.2446
3rd rest period1.5181.3667
Separated mattressesOne mattress
1st rest period1.60091.393
2nd rest period1.79991.3567
3rd rest period1.77681.3741