Upload
others
View
1
Download
0
Embed Size (px)
Citation preview
1922 GE AOU Fan Power cord ReplacementReplace the power cord on a 1922 GE AOU fan.
Written By: Elias Dorna
1922 GE AOU Fan Power cord Replacement Draft: 2019-08-09Guide ID: 64228 -
This document was generated on 2019-09-16 07:46:33 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 5
INTRODUCTION
Use this guide to replace the power cord on a 1922 GE AOU fan.
TOOLS:Flathead Screwdriver (1)
PARTS:Cloth Wire Power Cord (1)
1922 GE AOU Fan Power cord Replacement Draft: 2019-08-09Guide ID: 64228 -
This document was generated on 2019-09-16 07:46:33 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 5
Step 1 — Power cord
Tip the fan to its side and remove the three size 8 screws using a 9/32 flat-head screwdriver.
The screws may be brittle from age, so be careful.
Take the bottom plate off the fan and set it aside.
Step 2
Remove the three number 8 screwsthat hold the switch in place.
1922 GE AOU Fan Power cord Replacement Draft: 2019-08-09Guide ID: 64228 -
This document was generated on 2019-09-16 07:46:33 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 5
Step 3
Remove the switch, carefully slidingthe speed lever out of its slot.
Don't remove the switch too quicklyor you can damage the head-wire.
Step 4
Once the switch is free, unscrew thetwo knurled nuts holding the wires inplace.
1922 GE AOU Fan Power cord Replacement Draft: 2019-08-09Guide ID: 64228 -
This document was generated on 2019-09-16 07:46:33 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 5
To reassemble your device, follow these instructions in reverse order.
Step 5
Turn the switch over and unscrewthe nut securing the wire with the5/16 crescent wrench.
Step 6
Remove the switch and set it aside,then pull the wire through thegrommet.
1922 GE AOU Fan Power cord Replacement Draft: 2019-08-09Guide ID: 64228 -
This document was generated on 2019-09-16 07:46:33 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 5