ADAPT-A-BELL™ AdapterMechanical Joint Threaded Adapter
The U.S. Pipe ADAPT-A-BELL™ adapter is a threaded adapter for mechanical joints on ductile iron pipe. Adhering to AWWA C151/A21.5 governing Ductile Iron Pipe, centrifugally cast for water, the adapter is available in diameters 4” through 24”.
Adapt-A-Bell adapter can be used on any threaded ductile iron pipe requiring a mechanical joint. The flanged end of the
adapter provides two different mounting options as the holes provided alternate between as cast and threaded holes. The adapter is rated to 350 psi
The most notable feature about the Adapt-A-Bell adapter is the overall thickness of the adapter. The "S" dimension is a minimum bell thickness per ANSI/AWWA C111/A21.11. The adapter not only exceeds this
thickness requirement at the point of measure, it maintains the “S” dimension thickness requirement throughout the threaded section of the casting. This section provides a stronger and more robust connection for the rugged demands of plant work applications.
PIPE
FABRICATION
RESTRAINED JOINTS
FITTINGS
GASKETS
COATINGS & LININGS
•
Headquarters
U.S. Pipe Two Chase Corporate Dr., Suite 200 Birmingham, AL 35244
866-347-7473
[email protected] www.uspipe.com
A Forterra Company
STANDARDS
� ANSI/AWWA C151/A21.5 Ductile Iron Pipe, Centrifugally Cast for Water.
� ANSI/AWWA C111/A21.11 Rubber-Gasket Joints for Ductile-Iron Pressure Pipe and Fittings.
� ANSI/AWWA C115/A21.15 Flanged Ductile-Iron Pipe with Ductile-Iron or Gray-Iron Threaded Flanges
� ASME B1.1 - Unified Inch Screw Threads, UN and UNR Thread Form
© 2017 U.S. Pipe. All rights reserved. USP-Adapt-a-bell Rev. 0317U.S. Pipe has a policy of continuous product and product data improvement and reserves the right to change design and specifications without notice.
C111 "S"DIMENSION
T = THICKNESS BEHINDTHREADS
GENERAL DESCRIPTION
MATERIAL: FABRICATED FROM PIPE MADE IN ACCORDANCE WITH ANSI/AWWA C151/A21.51
PRESSURE: 350 PSI
DIMENSIONS: MEETS OR EXCEEDS MJ BELL REQUIREMENTS PER ANSI/AWWA C111/ A21.11
FLANGE THREADS: IN ACCORDANCE WITH ANSI/AWWA C115/A21.15
BOLT HOLE THREADS: UNC-2B PER ASME B1.1
NOTES:
THE "S" DIMENSION EXCEEDS THE REQUIREMENTS OF ANSI/AWWA C111/ A21.11.
THE T DIMENSION MEETS THE REQUIREMENT OF THE
ANSI/AWWA C111/ A21.11 "S" DIMENSION.
GENERAL SPECIFICATIONS
Flanges are furnished with both drilled and tapped holes on the same BC.
MJ Adapt-A-Bell™ Adapter 4" -24"