Apple MacBook Pro SSD Installation 15” Models released between 2009 - 2012
What do I need?
Clear Workspace
New Solid State Drive Philips Screwdriver Torx T6 Screwdriver Spudger
To prevent potential damage from anti-static electricity, you should discharge yourself first.
This can be done by simply touching a grounded metal object, such as a radiator.
Installation Process
1 – Make sure the MacBook is
completely shut down and
switched off. Disconnect any
cables.
2 – Turn your MacBook over and
remove the 10 screws that are
securing the bottom case.
Remember where each screw came
from.
3 – Pry the back of the case away
from the MacBook.
7 x 3mm
3 x 13.5mm
Please visit mrmemory.co.uk for guides on cloning your
new SSD. This guide is for physical installation only.
4 – The Hard Drive will be in the
bottom left of the MacBook. Loosen
the Philips screws securing the hard
drive bracket to the upper case.
5 – Lift the drive by its plastic pull
tab and slide the SATA connector
off.
6 – Remove the T6 Torx screws from
the sides of the hard drive and
attach these to your new SSD. Also
stick the plastic pull tab onto the
new drive from the old. Attach the
SATA connector and slide drive into
place. Reattach the retaining
bracket.
7 - To reassemble the MacBook,
reattach the back panel and replace
the 10 screws into their locations.
Email – [email protected]
Tel – 01903 692 214