Step 1:To identify where the beginning of the brow should start, line the ANGLED BRUSH up
with the side of your nostril and hold it upright.
Step 2:To identify where the arch should start, line the ANGLED BRUSH
diagonally with the outer edge of your iris.
Step 3: To identify where the brow tail should end, hold the ANGLED BRUSH at an angle 45 degrees from the outer
corner of your eye.
Step 4: Using a clean disposal mascara wand, brush through the brows
moving in the natural direction of the hair.
Step 5: Now, assess whether the client has the following:
-Angular or rounded brow -Full, medium or thin brow
Step 7: If needed, use a concealer or foundation with the FLAT LINER BRUSH
to reshape brow if Step #6 was done incorrectly.
Step 8: Next, line the top of the brow, making sure to connect the topside’s tail end with the underside’s tail end
from Step #2.
Step 9: Double check the underside and topside of the arch to ensure they are in the correct position, (referring
back to Step #2), before moving forward.
Step 10: Fill in the inner part of the brow by using the ANGLED BRUSH and blending the underside line (Step #6) upwards toward the top of the brow.
Step 12: Using the FLAT LINER BRUSH, spread and blend the concealer or foundation downward toward the
eyelid.
Step 14: Use a FLAT EYESHADOW BRUSH to lightly dust a loose or
pressed powder over concealer or foundation to set.
Step 15: Outline the topside of the brow, paying close attention to the
arch, with the FLAT LINER BRUSH and a concealer or foundation. Be sure to set it with a powder in the same manner
as Step #14.