How to Measure & ID
Week 1 Day 3
It is important that students understand the biology of trees to further be aware of trees’ role in the
ecosystem throughout its life.
Seedling
Seed
Sapling
Mature Oak
Snag
Like all living things trees have a life cycle: Birth Growth Aging Death
As trees grow, their physical form changes as does their role in the forest ecosystem
Seeds come in a variety of shapes, weights, colors, and sizes, depending on the species. Seeds develop from male and female parts of the trees
producing fruits. Some seeds are in a protective nut like an acorn
Others are in fleshy fruits, like the black cherry. The fruit of a pine is a cone and the seed is winged and
resembles a miniature helicopter when falling. Wind, water, animals, and people disperse seeds to
the forest floor, open fields, yards and roadsides. Where conditions are favorable for germination, seeds
will germinate and grow.
Which came first - the tree, or the seed?
The seedling grows and begins to develop woody characteristics.
The stems harden, change color, and develop a thin protective bark.
The stem may bend or develop branches that reach toward light.
Leaves or needles that develop are adapted to shade, but lean or tilt toward light.
Most roots are in the upper soil to absorb water, nutrients and air.
Seedlings compete for nutrients, water, sunlight, and space.
Threats include fire, flood, drought, disease, insect attacks, and animals.
At this stage the tree is most susceptible to being killed.
When the tree is about 1-4 inches in diameter at 4.5 feet, it is considered a sapling. standard height where tree’s diameter is
measured – diameter at breast height (DBH). As the tree starts to get taller the trunk
thickens and branches develop. A sapling is the size of a tree growing in a
nursery. In this juvenile state, the tree is not
mature enough to reproduce. Growing rapidly, the sapling has the
same competition and threats as seedlings.
With favorable conditions, a sapling will grow into a mature tree (>4 inches DBH).
During this stage, each tree will grow as much as its species and site conditions will permit.
In addition, flowers develop, reproduction ensues, fruits form, and seed dispersal can now occur.
Trees provide the maximum environmental benefits to people during this stage.
What does DBH mean?
What plant in the picture would you say is a
mature tree?
The life span of a tree is a wide-range, yet death is inevitable.
A combination of factors overcome a tree and causes it to die. Injury, drought stress, followed by disease, rot,
root dieback, coupled with a lightning strike or insect infestation contribute to tree decline.
Sometimes a single factor is serious enough to cause mortality.
Standing dead trees, called snags, play vital roles in the life cycle of many organisms.
A snag slowly breaks down and returns nutrients as limbs, bark, and branches fall. It provides habitat and food for wildlife and insects.
Animals, insects, and fungi help break down the tree. Eventually, the snag will fall and return
nutrients to the soil where they are takenup by other trees.
And, the cycle begins anew.
What stage of the lifecycle are these trees
in currently?
SEEDLING
What stage of the lifecycle are these trees
in currently?
SNAG
What stage of the lifecycle are these trees
in currently?
SAPLING
Have you ever measured anything? WHAT? HOW?
WHY?
Why do people measure things?
In what ways do people measure things?
1. Use the length of your index finger to measure the width of you textbook.
2. Use the length of your forearm to measure the height of your desk.
Record the results in your packet.
How many finger lengths is your book?
Why did people get different measurements?
Compare your index finger with your
neighbors.
How can we make sure our measurements are
accurate?
Plan harvesting Make forest management decisions Monitor forest health
Tree diameter is an important forestry measure and is used to indicate how well a tree is growing over time.
It is also one of the standard measures of timber volume used to estimate the commercial value of a forest stand.
By convention, the diameter is measured at a height on the trunk that is 1.35 m (4.5 ft) above ground level.
This height above the ground is used because uneven swelling and irregular growth at the base of the tree and upper roots could mask the true growth of the trunk.
What would happen if people measured tree
circumference at different heights?
This is a horizontal measurement: leaf tip to leaf tip of the shortest spread leaf tip to leaf tip of the longest spread through the main mass of the tree canopy Add the two numbers together, and divide by two for the
average crown spread
Crown spread is difficult to measure when branches are high. Have 2 people stand where the tips of the farthest branches are directly overhead. A 3rd person can measure the distance at ground level.
3 .5 feet
1 .5 feet
What is the crown spread of this tree? 2.5 feet
What is the crown spread of this tree?
11 feet
8 feet
9.5 feet
What characteristics would you use to identify trees? Look at the twigs on your desk for ideas.
Look at several different features Leaves Bark Twigs Flowers Fruit Seeds Shape
How do you think you use a book like
this to identify trees?
In the simplest sense we have 2 types of trees:
Conifers (coniferous) : seeds develop in cones, have needle shaped leaves don’t lose leaves each year so stay green = evergreens Pines, spruces, hemlocks and firs
Broad-leaf (deciduous) : broad, flat leaves that they lose each year Oaks, maples, beeches and aspens
Differ in many ways and help identify treesTips may be pointed, rounded, tapered…Bases may be squared, rounded, heart-
shaped…
What are the shapes of these 3
leaves?
PALMATE!
HEART-SHAPED!
ROUND OR OVAL!
1
2
3
Edges or margins of leaves give clues to tree identity Teeth (serrated) Lobed Smooth (toothless)
What type of leaf margin do these
leaves have? LOBED!
Completely hairyHairs on one sideCompletely smoothThick, thin, rough or waxy
Simple leaves have only one piece to them Maple, oak, aspen and
sycamore
Compound leaves are made-up of several leaflets Ash, walnut and sumac
trees
Are these leaves simple or
compound?
1
2
3
4
5 6
The way the leaves are arranged on the twigs Alternate, opposite, whorls
What kind of leaf arrangements are
these? ALTERNATE!
Even leafless twigs can help identify trees. Look for the leaf scars (leaves used to be there) or buds
on the twig to see if leaves grow alternate, opposite or whorled.
Size, color, texture, and shape of buds also help identify trees.
Spines, thorns, prickles and other surface features also help.
What type of leaf scar pattern do
these twigs show?
1
2
ALTERNATE!
OPPOSITE!
Various tree species produce characteristic fruits.
Deciduous tress produce berries, winged samaras, nuts, or drupes. Some have unique names (acorns, walnuts, and chestnuts).
Conifers produce different cones that vary in shape, size, and arrangement of scales.
Identify with the color and textureShaggy, smooth , rough or deep furrowsExample: Paper Birch – white, paper-likeUse bark on trunk, not branches
Paper Birch
Characteristic shapes can identify trees Rounded, weeping, vase-to Funnel, tabular and conical Some people are able to look at a tree in the distance and
know what kind it is