©2010 Engines and Energy Conversion Laboratory
Operation of Internal Combustion Engines on Digas for Electricity Production
Livestock & Poultry Environmental Learning Center National Conference: From Waste to Worth: “Spreading” Science & Solutions
Grand Hyatt Hotel, Denver, ColoradoApril 1-5, 2013
Daniel B. OlsenAssociate ProfessorMechanical Engineering Dept.
2April 10, 2023
• Stationary Gas Engines• Digas Characteristics• Engine Design Modifications for Digas• Gas Scrubbers• Digas Installation
Outline
Digas Engine Design Options1. Compression Ignition (Diesel) Engine
– Blend biogas with intake air– Requires two fuels on site
2. Spark Ignition Stoichiometric Gas Engine– 3-way catalyst for emissions control– Lower efficiency
3. Spark Ignition Lean-burn Gas Engine– Low emissions– High efficiency– High power density (bmep)
3
Stationary Gas EnginesPower generation, Combined heat and power, Gas compression Pumping
Wärtsilä 34SG
Waukesha VGF
KUBOTA DG972-E2
Jenbacher Type 2
Cummins Genset
Caterpillar 3516C
4
Guascor V16
MAN CHP
Efficiency Trends
5 Heywood, J. B., “Internal Combustion Engine Fundamentals”, McGraw-Hill, Inc., 1988.
34%
35%
36%
37%
38%
39%
40%
41%
42%
100 150 200 250 300 350 400
bmep (psi)
Increasing boost & power at constant A/F
• Higher power density (bmep) results in higher efficiency
• Higher compression ratio yields higher efficiency
Waukesha VGF (F18GLD)
• Knock (detonation) limits compression ratio of engine
• Fuel quality determines knock limit
Fuel A Knock Limit
Fuel B Knock Limit
Efficiency
6April 10, 2023
• Stationary Gas Engines• Digas Characteristics• Engine Design Modifications for Digas• Gas Scrubbers• Digas Installation
Outline
Biogas Composition
• Two general types of biogas– Wood gas from a gasifier– Digas from sewage
processing, landfill, etc.• Very different properties
from each other and from natural gas
• Our focus is on digas from agricultural systems
7
Wood Gas % Composition
Nitrogen, 55.4%
CO, 20.6%
Hydrogen, 18.4%
Methane, 2.2%
Oxygen, 1.8%
CO2, 1.3%
Test Results
62.4
30.0
61.570.2 66.3
23.9
139.1 139.6
0
20
40
60
80
100
120
140
160
1, ReformedNatural Gas
2, Coal Gas 3, Wood Gas 4, Wood Gas 5, DigesterGas
6, Landfill Gas 7, ReformedNatural Gas
8, Coal Gas
Met
ha
ne
Nu
mb
er
Typical Natural Gas
Validation Gas %CH4 %C2H6 %C3H8 %C4H10 Leiker, et al.
Measured MN (± 1.5) AVL 6 69 20 11 54.8 AVL 9 93 4.3 2.7 75 AVL 10 91 4.2 2.7 2.1 65.6 AVL 11 49 19 32 43.8
# Test Gas %CH4 %H2 %N2 %CO %CO2
1 Reformed
Natural Gas 39.7 46.7 0.8 0.9 11.9
2 Coal Gas * 24.8 16.3 58 1 3 Wood Gas 10 40 3 24 23 4 Wood Gas 1 31 35 18 15 5 Digester Gas 60 * 2 * 38 6 Landfill Gas 60 * * * 40
7 Reformed
Natural Gas 1.2 30.8 49.0 15.6 3.4
8 Coal Gas 7 44 * 43 6
8
Crit
ical
Com
pres
sion
Rat
io
Malenshek M., Olsen D.B., “Methane number testing of alternative gaseous fuels”, Fuel, Volume 88, pp. 650-656, 2009.
Hydrogen Sulfide (H2S)• Digas levels ~2000-5000 ppm H2S from hog and
cattle digesters• Impact on engines
– Corrodes copper-based bearing materials– Contaminates oil via blow-by– Combustion of H2S produces SO2
9
/
10April 10, 2023
• Stationary Gas Engines• Digas Characteristics• Engine Design Modifications for Digas• Gas Scrubbers• Digas Installation
Outline
Case Study: Waukesha 16V150LTD (152 mm Bore x 165 mm Stroke)
• 1.1 MW at 1800 rpm, 15.8 bar bmep
• Regulator spring replaced with stiffer spring to increase fuel pressure
• Fuel piping from regulator to mixer increased from 3” to 4”
• Mixer insert flow area for digas increased by 2.3X relative to natural gas
11Reinbold, E. and von der Ehe, James, “Development of the Dresser Waukesha 16V150LTD Engine for Bio-Gas Fuels”, ASME Internal Combustion Engine Division 2009 Spring Technical Conference, ICES2009-76079, May 3-6, 2009.
Case Study: Waukesha 16V150LTD (152 mm Bore x 165 mm Stroke)
• For 1 g/bhp-hr NOx for NG (900 Btu/SCF) to digas (400 Btu/SCF), respectively,– Timing 21to 30bTDC– Lambda 1.70 to 1.42
• Slightly lower digas boost requirement due to richer lambda
12Reinbold, E. and von der Ehe, James, “Development of the Dresser Waukesha 16V150LTD Engine for Bio-Gas Fuels”, ASME Internal Combustion Engine Division 2009 Spring Technical Conference, ICES2009-76079, May 3-6, 2009.
Biogas operating envelope shift
LeanRich
13April 10, 2023
• Stationary Gas Engines• Digas Characteristics• Engine Design Modifications for Digas• Gas Scrubbers• Digas Installation
Outline
14April 10, 2023
Digas Specifications
Guascor Power, “Anaerobic Digestion Gas Fuel Specifications – Landfill and Digester Gas”, Product Information IC-G-D-30-003e, Sept 2011.
ManufacturerRelative
Humidity (%)Temperature
( C)H2S (mg/MJfuel, ppm) NH3 (mg/MJfuel, ppm) PM (mg)
D-R Guascor < 80 > 15 above DP < 70, 990 < 1.5, 42 < 5
Jenbacher < 80 < 40 < 21, 290 < 1.4, 39 < 5
Caterpillar < 80 -10 to 60 < 57, 810 < 2.8, 79 < 1
Notes:1 - Relative humidity specification is at the engine fuel gas inlet connection.2 - Calulation of ppm values based on Guascor SFGLD240 Biogas engine flowrates, operating on biogas 60% CO2, 38% CO2, and 2% N2.
3 - Caterpillar values given as an example; actual specification is dependent on engine and application.4 - Sulfur specifications are without a catalyst; limits are lower if a catalyst is required.
15April 10, 2023
• Iron Oxides– Remove sulfur by forming insoluble
iron sulfides– Iron-oxide-impregnated material (wood-chips,
ceramic, ..)– Removal reactionFe2O3 + 3H2S Fe2S3 + 3H2O, ΔH= -22 kJ/g-mol H2S
– Regeneration reaction2Fe2S3 + O2 2Fe2O3 + 3S2, ΔH= -198 kJ/g-mol H2S
H2S Removal: Iron Oxide
Steven McKinsey Zicari, “Removal of Hydrogen Sulfide from Biogas Using Cow-Manure Compost”, MS Thesis, Cornell University, 2003.
16April 10, 2023
• Filter media provides environment for establishment of a bacteria biofilm.
• As the biogas comes in contact with the biofilm, hydrogen sulfide is solubilized and subsequently oxidized by the microbes.
• Sulfur and sulfate compounds are formed as by-products and are collected at the bottom or purged with re-circulated water.
H2S Removal: Biotrickling
17April 10, 2023
• Stationary Gas Engines• Digas Characteristics• Engine Design Modifications for Digas• Gas Scrubbers• Digas Installation
Outline
18April 10, 2023
• Raw digas contains 4000-5000 ppm H2S
• Biotrickler is used to reduce H2S to 200-300 ppm
• Typical gas composition supplied to engines: 57% CH4, 40% CO2, 2% O2, 250 ppm H2S, and 1% other trace species.
• Two Guascor SFGLD560 V16 engines, rated at 788 kW at 1200 rpm
• Nominal Operating Parameters:− 525 CFM total digas supply (both engines)− Engines typically produce 730 kW each, supplying just over 100% of
dairy electricity in winter and 2/3 of electricity in summer
• Oil is changed every 500 hours; currently 8500 hours since install without rebuild
Windy Ridge Dairy Farm, Fair Oaks, Indiana (Martin Machinery Installation)
19April 10, 2023
Windy Ridge Dairy Farm, Fair Oaks, Indiana (Martin Machinery Installation)
Digester maximum manure temperature 105F.Digester residence time typically 25-30 days.
20April 10, 2023
Windy Ridge Dairy Farm, Fair Oaks, Indiana
Manure Supply to Digester
Digester : 100 X 80 yards X 20 feet deep
Clockwise from left: biotrickler, rough water dropout, and iron sponge
Biotrickler control skid
Sulfur and sulfate compound collection
Guascor SFGLD560 V16
engine
21April 10, 2023
Contact:
Daniel B. Olsen
Associate Professor
Mechanical Engineering Department
(970) 491-3580