PSEUDO G1000 Academics
Not to be mistaken for the actual Cessna built course!
Objectives
• Walk out knowing something new about the G1000 equipped CAP aircraft– Some ‘nice to know’ things about the PFD/MFD– Audio panel ops and limitations– Not overwhelm you with minutia
G1000 Audio Panel (GMA 1347) locations
GMA 1 (Pilot side) GMA 2 (Co-Pilot side)
COM1MIC
COM1
COM2MIC
COM2
COM3MIC
COM3
COM1/2
TEL
PA SPKR
MKRMUTE
HISENS
DME NAV1
ADF NAV2
AUX
MANSQ
PLAY
PILOT COPLT
DISPLAY BACKUP
PILOT--- ---COPLT PASS
COM 1/2 is disabled; creates transmit conflicts
PA is disabled; SPKR is operative
DME and ADF are disabled;
PLAY is disabled
DF receive = AUX
COM1MIC
COM1
COM2MIC
COM2
COM3MIC
COM3
COM1/2
TEL
PA SPKR
MKRMUTE
HISENS
DME NAV1
ADF NAV2
AUX
MANSQ
PLAY
PILOT COPLT
DISPLAY BACKUP
PILOT--- ---COPLT PASS
External FM/UHF switch controls connection to either radio, one at a time, no priority
FULL DUPLEX connection to telephonic device
DF (receive only)
Selecting MIC auto selects same RX; select other desired audio button(s) to listen to multiple radios
SEAT1
SEAT2
SEAT3
SEAT4
PILOTGMA 1
COM1 priority
CO-PILOTGMA 2
COM2 priority
PASSENGERGMA 2
PASSENGERGMA 2
SEAT 2/3 SWITCH OPS(normal position)
Controls what seat is connected to GMA 2(priority position)
SEAT1
SEAT2
SEAT3
SEAT4
PILOTGMA 1
COM1 priority
PASSENGERGMA 2
PASSENGERGMA 2
CO-PILOTGMA 2
COM2 priority
SEAT 2/3 SWITCH OPS(switched position)
Controls what seat is connected to GMA 2(priority position)
COM1MIC
COM1
COM2MIC
COM2
COM3MIC
COM3
COM1/2
TEL
PA SPKR
MKRMUTE
HISENS
DME NAV1
ADF NAV2
AUX
MANSQ
PLAY
PILOT COPLT
DISPLAY BACKUP
PILOT--- ---COPLT PASS
Mutes the selected MKR BKN audio; unmutes when new audio is received (also stops PLAY audio)
Increases MKR BKN sensitivity; press again to return to normal
Enables manual squelch for intercom; when active, press PILOT knob (inner) to illuminate and adjust using PILOT or COPLT knobs
Manually selects reversionary mode(turns MFD into a PFD repeater)
COM1MIC
COM1
COM2MIC
COM2
COM3MIC
COM3
COM1/2
TEL
PA SPKR
MKRMUTE
HISENS
DME NAV1
ADF NAV2
AUX
MANSQ
PLAY
PILOT COPLT
DISPLAY BACKUP
PILOT--- ---COPLT PASS
There are 4 intercom ‘isolation’ modes:
PILOT – pilot aloneCOPLT – co-pilot alone
(remember SEAT 2/3 switch?)Both selected – CREWNeither selected – OFF
Passengers can always talk among themselves, and can talk to ‘crew’ as well, unless isolation is selected
Failures• “Onside” COM for that panel as Primary
• Pilot – COM1• Co-Pilot – COM2
• Whoever is the CO-PILOT selected position
• Additional Receive only option• Pilot – COM2• Co-Pilot – COM1
PFD/MFD Failures• Reversionary Mode – MFD reverts to PFD in the event of total PFD failure
• Individual Component failure – PFD displays invalid/incorrect information with a RED X
• Reference System• Air Data Computer• Integrated Avionics (including Engine Analyzer)• Engine Analyzer only
• Audio Panel specifics
• “Onside” COM for that panel as Primary• Pilot – COM1• Co-Pilot – COM2
Sometimes we DO just have to use the brute force method!
PRACTICE, PRACTICE, PRACTICE!
Recommended
