INTRODUCTION:

Thermocouples are regularly at the end of the two wires, where the two wires are combined together to make an intersection of two different metals. The Thermocouple Wires are made of different metals along these lines they act distinctively at diverse temperatures. Bad thermocouples are an exceptionally normal problem for a water heater.

Tips on How to Replace a Water Heater Thermocouple

THERMOCOUPLES

Thermocouples are regularly at the end of the two wires, where the two wires are combined together to make an intersection of two different metals. The Thermocouple Wires are made of different metals along these lines they act distinctively at diverse temperatures. Bad thermocouples are an exceptionally normal problem for a water heater. The thermocouples are the thing that keeps the pilot fire lit. In the event that the thermocouple goes awful, the pilot light will go out and you will have no high temp water. Figuring out how to supplant it will spare you time and cash. There are some step by step instructions listed below that you can follow to save you money when Water Heater Thermocouple needs to

repair.

Materials you needed when repairing your Water Heater Thermocouple:

Thermocouple

Screwdriver

Crescent wrench

Here are the steps – by – steps instructions to follow:

1. Turn your gas shut off valve to the shut position and keep in our mind, this is the first thing you need to do for your safety. They shut off handle will be perpendicular to the channel. Expel the spread from the burned area. Check if properly.

2. Utilize a sickle wrench to unthread the pilot, the thermocouple and the primary gas connection from the gas valve. Do this carefully!

3. When you are done for it, remove the burner panel. In the event that it’s a sparkle ignitor then you will most likely need to uproot four screws, as on this one. On the non-spark models the board simply slides out.

Tips on How to Replace a Water Heater Thermocouple

THERMOCOUPLES

4. With the panel removed, you can take out the entire burner gathering. Keep in your mind that you need to follow all the instruction so you replace your Water Heater Thermocouple correctly.

5. The thermocouple either slides out or is strung out. You are required to tap it out with the end of your wrench and if you are having some trouble with a slide out thermocouple. A general pack will consider every contingency, it's not an idea thought to request a couple and keep some available.

6. Slide the burner to get together back and reconnect the pilot, gas, main gas, and the thermocouple. Relight the pilot.

REFERENCES:

The Green Book: http://www.thegreenbook.com/products/thermocouples

Deviantart: http://thermocouplesdetails.deviantart.com/journal/Tips-on-How-to-Replace-a-Water-Heater-Thermocouple-489979209

Image Source: Flickr.com