Upload
ronaldps9
View
117
Download
0
Embed Size (px)
DESCRIPTION
Citation preview
COMPANY LOGO
www.themegallery.com
LOGO
GLOSSARY
SETUP BIOS
COMPANY LOGO
www.themegallery.com
MEMBERS
Ronald Pereira
COMPANY LOGO
www.themegallery.com
terms
Auto Suspend Timeout: After the selected period of inactivity, the computer automatically enters Suspend mode.
BIOS PM Timers: After the selected period of inactivity for each subsystem (video, harddrive, peripherals), the subsystems enters STANDBY mode.
Cache Read Burst: Set the time (Q1, Q2) for the processor to perform a reading from the cache burst mode.
CPU Fan on Temp High When the processor reaches the set temperature the heatsink fan is placed in operation.
Date: The BIOS determines the day of the week from the date information (for information.)
COMPANY LOGO
www.themegallery.com
EDO Read WS Select the correct combination of clock cycles in accordance with the design of the motherboard and EDO memory specifications.
FDD Detection When Enabled, any floppy activity cancels the power saving mode and resets the inactivity timer.
HDD Power Down After the selected period of inactivity, the hard drive powers down while all other devices.
IN0-IN6 (V) These points enable you to display the voltage of up to 7 input lines, if your computer has a system monitoring.
ISA Clock You can set the speed of the bus at one-third or one fourth of the processor clock speed.
Joystick Function Select Enabled if your computeris connected to a joystick.
KBC input clock The manufacturer must select the correct frequency for the clock controller keyboard. Do not change this value.
terms
COMPANY LOGO
www.themegallery.com
terms
MPU-401 I / O Base Address Select a base address input / output for MPU-401 interface.
Page Mode Read WAS: Select the right combination of clock cycles to the specifications of the motherboard and the specifications of the DRAM FPM (Fast PageMode).
PM Control by APM When installed on your computer's advanced Power Management (APM), selecting Yes gives better power savings.
RTC Alarm resume: Sets the date and time for the computer wakes from sleep mode.
Sleep Clock Select CLOCK STOP (stop the clock) or SLOW CLOCK (lower clock speed) in energy saving mode.
USB Controller Select Enabled if your computer has a controller for Universal Serial Bus (USB) and USB devices are available.
VGA Active Monitor When Enabled, any videoactivity restarts the timer to STANDBY mode.
Video Off Method This determines the manner in which the monitor is turned off.