Upload
mrmohan
View
25
Download
3
Tags:
Embed Size (px)
Citation preview
Design and programing of Relay Menu
Interfacing LCD And Keyboard
Design and Simulation of ZCD
Design and Simulation of Measurement of Voltage Magnitude
8
80
100
100
7
40
90
100
0 0
35
85
5
40
75
95
27TH JAN 15TH FEB 1ST MAR 15TH MAR
PROJECT PROGRESS
PF V and I MHO Total
• Interfacing of LCD.
• Interfacing of Keyboard.
• ON/OFF Control.
• Reset.
• Menu.
• UP/DOWN/LEFT/RIGHT for navigation.
• Menu Consist of
• MTA Setting.
• Zone 1, Zone 2, Zone 3 impedance setting.
4/14/2014Electrical Department PES University
• Zero crossing detector(ZCD) is a voltage comparator that switches the output between +Vsat and –Vsat when the input crosses zero reference voltage.
• Working of ZCD can be easily understood if you know the working of a basic op amp comparator.
• In ZCD, we are setting one of the inputs as zero i.e. zero reference voltage.
• The output is driven into –Vsat when the input signal passes through zero to positive direction.
• Conversely, when input signal passes through zero to negative direction, the output switches to +Vsat.
4/14/2014Electrical Department PES University
4/14/2014Electrical Department PES University
Multisim 13 VBB StudioProteus 8
4/14/2014Electrical Department PES University
4/14/2014Electrical Department PES University
4/14/2014Electrical Department PES University
• Output wave from ZCD for Current input is square wave with 50Hz frequency
• Output wave from ZCD for Voltage input is square wave with 50Hz frequency
• Output magnitude of ZCD is equal to VCC (3.56v, 5v, 12v)
4/14/2014Electrical Department PES University
• Current sensor is used to get corresponding voltage output and wave.
• From the output wave we will get current zero crossing and magnitude.
4/14/2014Electrical Department PES University
• High voltage is converted into low voltage by step down transformer.
• Analog voltage converted into Digital by ADC.
• Voltage magnitude is found by sampled digital value.
4/14/2014Electrical Department PES University
• From the ZCD we will get square wave for current and voltage zero crossing.
• The time gap between this 2 output wave of ZCD is found.
• From the time interval Power factor is calculated.
4/14/2014Electrical Department PES University